Thermador WDC36J Use & Care Manual

Page of 40
Operation
About the Appliance
The warming drawer will keep hot, cooked foods at serving 
temperature. Always start with hot food. DO NOT use to 
heat cold food other than crisping crackers, chips, dry 
cereal or warming dishes or plates.
General Information
Power Requirements and Grounding
Circuit Specifications: 120V, 15A, 60Hz, 3-wire, grounded 
outlet. The outlet must be properly grounded in accordance 
with all applicable codes. 
It is the responsibility of the installer to comply with local 
codes. If no local codes are applicable, wire in accordance 
with the National Electrical Code, ANSI/NFPA 70 - latest 
edition.
Features
Warming Timer
The warming timer can be set for any increment of 5 
minutes. The minimum time is 5 minutes and the maximum 
is 5 hours. The warming timer default is 1 hour. When the 
time is elapsed, the warming timer beeps and the drawer 
automatically turns off.
Changing the Warming Timer:
Use the + and - pads to change the warming timer.
Operation 
Before using, clean the drawer thoroughly with hot, soapy 
water. There may be some burn off and odors on first use 
of the appliance—this is normal.
Use heat-safe dishes only.
Preheating the Warming Drawer
Preheat the warming drawer when keeping food warm. For 
best results, preheat for the following times: 
LOW: 6 minutes
MED: 12 minutes
HIGH: 20 minutes
PLATES: Do not preheat the drawer.
The warming drawer will deliver a set of beeps once pre-
heating is complete.
Disabling the Convection Heater
The stand alone warming drawer is programmed to use a 
convection heater during preheat for a quicker heating 
time. If the user chooses not to use the blower while 
preheating the warming drawer (for instance, if there is 
concern about the blower drying out the food), the 
convection heater can be disabled during preheat. 
1. Press and hold the desired mode button (LOW, MED, 
or HIGH) for 3 seconds. 
The light over the mode button will blink during preheating 
and the convection fan will not operate.
There is no convection heater override for PLATES mode.  
Keeping Food Warm
1. Press the pad for the desired temperature setting.
2. Set the warming timer.
3. Place cooked, hot food in the drawer.
It is okay to leave food in the cookware it was prepared in. 
Alternatively, you can transfer food to a heat-safe serving 
dish before placing it in the warming drawer.
Aluminum foil may be used to cover food.
CAUTION: 
DO NOT use plastic wrap to cover foods or plastic 
containers in the warming drawer. Plastic containers or 
plastic wrap can melt if in direct contact with the drawer 
or a hot utensil. If it melts onto the drawer, it may not be 
removable.
WARNING: 
DO NOT use aluminum foil or protective liners to line any 
part of the appliance. Installation of these liners may 
result in a risk of electric shock or fire.