Lynx L42ASFRNG Owner's Manual

29

note:
lynx built-in grills are intended 

either for installation in a 

built-in enclosure constructed 

of non-combustible materials 

or for an installation in a built 

in enclosure constructed of 

combustible material when 

installed with a lynx insulating 

jacket (liJ).
for non-combustible applica-

tions, the grill drops into the 

opening shown in the cutout 

detail drawing 

(see indeX: “gas 

Requirements”)

 and hangs from 

its counter-top trim. a deck is 

not required to support it from 

the bottom. 
when using the insulated 

jacket in a combustible 

enclosure, the jacket must be 

supported from the bottom by 

a ledge on each side or a full 

deck beneath the jacket.

(See INDEX: “Gas Requirements”)

 

pay special attention to the 

provisions shown for gas line 

hook-up.
the enclosure should have 

ventilation holes to prevent 

gas build-up in the event of 

a leak. the deck ledges and 

counter should be flat and 

level. (refer to ansi Z21.58 

standard for outdoor cooking 

gas appliances, section 1.7 

enclosures for self contained 

lp-gas supply systems)
This grill requires that a 120 

volt, 60 hertz, 15 amp gfi 

certified outlet be installed by 

a qualified electrician. 

minimum clearance from the 

sides and back of the grill to 

adjacent combustible con-

struction below the top of 

unit are 12” from the sides 

and back. 
dégagement minimal entre 

les parois latérales et l’arrière 

de l’appariel et la construc-

tion combustible au-dessous 

du panneau supérieur de 

l’appareil (30 cm à partir des 

parois latérales et 30 cm à 

partir de l’arrière). 
minimum clearance from 

sides and back of unit to 

adjacent combustible con-

struction extending above the 

unit is 18” from the sides and 

back. 
dégagement horizontal 

minimal entre les parois 

latérales et l’arrière de 

l’appariel et la construction 

verticale combustible au-

A 3 inch clearance is required behind the grill to allow the front 

hood to open. 
the grill exhausts combustion products and cooking greases to 

the back. Never locate the grill where this exhaust will be difficult 

to clean. 

(3” min)

dessus de l’appareil (45.7 cm 

à partir des parois latérales et 

45.7 cm à partir de l’arrière). 
do not use this appliance 

under overhead combustible 

surfaces. 
ne pas utiliser cet appareil 

sous une surface combus-

tible. 
a minimum of 6” of clearance 

is needed on the left side of 

the grill above the counter 

top for the motor and skewer. 
if the grill is to be placed into 

a combustible enclosure, an 

approved insulated jacket 

is necessary and is available 

only from your lynx dealer. 

lynx insulated jackets have 

been designed and tested 

specifically for your Grill.