Lynx L42ASFRNG Owner's Manual

33

the grill is factory set to use 

either propane (lp) or natural 

gas (nat). it is critical that the 

gas you use matches that 

which the grill was set up for.  

you can verify that by 

checking the 

rating plate

. 

the rating plate is located in 

one or more of the following 

places: 

 

► attached to the underside 

of the drip tray 

 

► on the heat shield behind 

the front panel 

 

the Rating plate lists serial numbers, 

model numbers and gas type. this 

one is underneath the drip tray.

ensure that the gas supplied 

meets with the minimum 

pressure requirements. Do not 

operate the grill on any gas 

other than that for which the 

grill has been set.

fuel

wc 

max 

inlet

wc min 

under 

full load

nat gas

7 in

4 in

lp

14 in

11 in

Water Column Requirements 

Both the regulator and the 

manifold orifices have been 

tuned for the type of gas 

specified on the rating plate. 
converting to a different type 

of gas requires a conversion 

kit, available from lynx or 

from your dealer and must be 

installed by a qualified techni-

cian. 
all installation and all instal-

lation parts must conform to 

local codes with the national 

electrical code, ansi Z223.1/

nfpa 70 latest edition and 

the national fuel gas code, 

ansi Z223.1/nfpa 54 in the 

u.s and cga-B149.1/.2 in 

canada.
canadian installations must 

conform to cga-B149.1/.2 

natural gas/propane installa-

tion code. (canada) 

lynx recommends that 

only qualified profession-

als perform the required 

plumbing on this product.
to ensure satisfactory per-

formance, the gas supply 

line must be sized to ac-

commodate the total Btu 

requirements of all the gas-

fired equipment that will be 

connected to that line. 
in no case should pipe less 

than 3/4” inside diameter or 

1” outside diameter ever be 

used to connect this product.

 

► calculate the total Btu 

output of all equipment 

and refer to “indeX: gas 

supply line Runs” for 

allowable run distances 

for ¾ inch pipe.  failure 

to meet these minimum 

requirements may reduce 

performance of the grill 

and any other appliances 

running on that supply line. 

 

► always keep supply line 

runs as short as possible. 

(see indeX: “Btu output” for 

specific model ouputs)

 

► a gas shut-off valve must 

be installed in an easily 

accessible location by a 

qualified plumber. 

Never coNNect a gas liNe directly to the grill. a pressure regulator must be 

iNstalled oN all gas equipmeNt. all local codes require it aNd lyNx supplies the 

correct regulator with your grill. removiNg or failiNg to iNstall the pressure 

regulator caN result iN fire aNd serious persoNal iNjury aNd will void the  

warraNty.