Lynx L42ASFRNG Owner's Manual

36

 

► product installation must meet local electric codes or, in the absence of local codes, the latest 

edition of the national electrical code ansi/nfpa no. 70 or the canadian electrical code 

cga 1.6b2005.

 

► use only a ground fault interrupter (gfi) protected circuit with this outdoor cooking gas ap-

pliance. 

 

► Important:  When connecting your rotisserie motor, first connect the motor to the grill and 

then plug the grill into the outlet.

 

► This grill is equipped with a three prong (grounding) electric plug for your protection against 

shock hazard and must be plugged directly into a properly grounded three prong outlet. 

neVeR cut or remove the grounding prong from this plug. 

 

► Use only extension cords with a 3 prong grounding plug, rated for the power of the equip-

ment, and approved for outdoor use with a “w-a” marking.

 

► to protect against electric shock, do not immerse any part of the power cord, an extension 

cord or any plugs in water or other liquid.

 

► unplug the product from the outlet when not in use and before cleaning. allow it to cool 

before putting on or taking off parts.

 

► do not let the cord hang over the edge of a table or touch hot surfaces.

 

► do not use an outdoor cooking gas appliance for purposes other than intended.

 

► do not operate any outdoor cooking gas appliance with a damaged cord, plug, or after the 

appliance malfunctions or has been damaged in any manner. contact the manufacturer for 

repair.

Installation requires an 

outdoor 120Vac 15a gfi 

(ground fault interrupter) 

electrical outlet adjacent to 

the grill. 
the gfi outlet features an 

internal breaker that reduces 

shock hazard. this type of 

outlet should be installed by 

a qualified electrician either 

inside the island enclosure 

for built-in units, or near the 

location where a free-standing 

unit will be used.  

for built-in grills, the supplied 

12V transformer is connected 

to the grill during installation. 
when installing the trans-

former to the grill be careful 

to prevent the wiring and 

transformer from contacting 

any hot surfaces behind or 

below the grill. it is recom-

mended that the transformer 

be located below the grill in 

a readily accessible location. 

Be sure to provide adequate 

access to facilitate service if 

the transformer or connec-

tions should need future main-

tenance.
if the electrical system fails to 

operate, a connection may 

have come loose in shipping 

or the gfi may have tripped, 

requiring a reset. See the 

troubleshooting section for 

more details.