GE GLDA696F Specification Sheet

Page of 2
Dimensions and Installation Information (in inches) 
For answers to your Monogram,
® 
Cafe
 Series,  
Profile
 Series or GE
®
 appliance questions, visit 
our website at geappliances.com or call GE 
Answer Center
®
 service, 800.626.2000.
Specification Created 7/13
350241
• The rough cabinet openin
g must be at least 
24" deep,
24" wide and appro
ximatel
y 32-1/2" to 
34-3/4" high f
flo
or to 
underside of the count
ertop.
   
 
 
 
 
 
   
 
4"
6"
5"
5"
4"
Figure A
Floor MUST be Even
W ith Room Floo
r
Cabinets
Square
and
Plumb
This Wall Ar
ea
must be Fr
ee
of Pipes or
wires
24"
Min.
24"
Min.
32-1/2"
 to 34-3/4"
Underside of
Countertop
to Floor
Plum bing and 
Electric Service
M ust Ent
er In
side This Ar
ea
Electrical Rating 
Voltage AC............................................................120 
Hertz......................................................................... 60 
Total connected load amperage................. 6.7 
Calrod
®
 heater watts max............................650
For use on adequately wired 120-volt,  
15-amp circuit having 2-wire service  
with a separate ground wire. This appliance 
must be grounded for safe operation.
Note: The rough cabinet opening must be at 
least 24" deep, 24" wide and approximately 
34-1/2" high from floor to underside of 
the countertop. Dishwasher must not be 
installed more than 10 feet from sink for 
proper drainage. All plumbing and  
electrical work must be in accordance  
with local codes. The power cord and  
connections must comply with the National 
Electrical Code Section 422 and/or local 
codes and ordinances. The cord must be no 
longer than 6 ft. from the junction box to  
the receptacle.
Installation Information: Before installing,  
consult installation instructions packed with 
product for  current dimensional data.
GLDA690FWW/GLDA690FBB/GLDA696FSS 
GE
®
 Stainless Steel Interior Dishwasher
 with Front Controls
Listed by 
Underwriters 
Laboratories