Amana AQC0501DRW Use & Care Manual

Page of 20
4
INSTALLATION INSTRUCTIONS
Unpacking
Remove Packaging Materials
Remove tape and glue residue from surfaces before turning 
on the freezer. Rub a small amount of liquid dish soap over the 
adhesive with your fingers. Wipe with warm water and dry.
Do not use sharp instruments, rubbing alcohol, flammable 
fluids, or abrasive cleaners to remove tape or glue. These 
products can damage the surface of your freezer. For more 
information, see “Freezer Safety.”
Clean Before Using
After you remove all of the packaging materials, clean the inside of 
your freezer before using it. See the cleaning instructions in 
“Freezer Care.”
Location Requirements
IMPORTANT:  Check the strength of the floor before installing 
your freezer. It should hold the weight of a freezer fully loaded with 
food.
Ventilation and Clearance
Keep flammable materials and vapors, such as gasoline, away 
from freezer.
Do not cover the freezer with items such as blankets, sheets, 
tablecloths, etc. This reduces air circulation. 
Allow at least a 3" (7.5 cm) clearance on both sides of the 
freezer and 2" (5 cm) between the back of the freezer and the 
wall. Leave room above the freezer to open the lid.
Temperature
Your freezer operates most efficiently when located in an area 
where the temperature is normally between 32°F (0°C) and 110°F 
(43°C). Do not install the freezer near an oven, radiator or other 
heat source.
Upon Moving to Final Location
1. Level the freezer from side to side and front to back so that 
the lid will seal properly. Use shims to level the freezer if 
necessary.
NOTE : It should not be necessary to remove the lid during 
installation. If, for any reason, the hinges need adjustment, 
contact a designated service company.
WARNING
Excessive Weight Hazard
Use two or more people to move and install freezer.
Failure to do so can result in back or other injury.
When Moving Your Freezer:
Your freezer is heavy. When moving the freezer for 
cleaning or service, be sure to cover the floor with cardboard
or hardboard to avoid floor damage. Always pull the freezer 
straight out when moving it. Do not wiggle or “walk” the 
freezer when trying to move it, as floor damage could occur.
Important information to know about glass shelves 
and covers:
Do not clean glass shelves or covers with warm water when 
they are cold. Shelves and covers may break if exposed to 
sudden temperature changes or impact, such as bumping. 
Tempered glass is designed to shatter into many small, 
pebble-size pieces. This is normal. Glass shelves and covers 
are heavy. Use both hands when removing them to avoid 
dropping.
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as 
gasoline, away from freezer.
Failure to do so can result in death, explosion, or fire.
2" (5 cm)
3" (7.5 cm)