Bosch B30BB830 Installation Instruction

Important note:
If the anti-tip brackets cannot be attached securely, 

an alternative anti-tip-device can be attached. However, 

ensure that there is no play between the appliance and 

the anti-tip-device. If possible, always screw the wooden 

beam to existing studs on the rear panel of the 

installation enclosure.
1. Saw the wooden beam (cross section min. 3" x 4") 

to the required length.
Length is equal to the width of the installation 

enclosure!
Note:



If the installation enclosure is deeper than the 

appliance, select a beam which has a larger 

cross section or attach 2 beams.



The beam must cover the appliance by 

at least 2" (50.8 mm).

2. Mark the installation height (lower edge of the beam) 

on the rear panel of the installation enclosure.

3. Select screws according to the thickness of the 

wooden beam: length = min. 2.5 x beam thickness, 

diameter #12 or #14.
Note:
Choose the number of screws according to the 

installation enclosure width, thereby ensuring that 

the beam can be attached securely.

4. Depending to the subsurface:

Locate wall studs in the rear of the installation 

enclosure and accordingly transfer their location to 

the wooden beam
or
fasten suitable dowel into the rear wall.

5. Predrill the wooden beam.
6. Attach the wooden beam to the rear panel of the 

installation enclosure.

To protect the edges of the installation enclosure, 

it is recommended to attach edge protection 

made of a suitable material.

The following are special installation 

steps. Instructions are provided after 

section C.



Change over door hinge, see “Special 

installation”.



Connecting the water, see  “Preparing 

to connect the water”.