Monogram ZICP360NHLH Installation Instruction

26

5.  Make the final vertical adjustment of the panels. Using 

the set screw at the top of the door and drawer, turn 
clockwise until the desired gap between the grille 
panel bottom and top panel of the door and the 
door panel bottom and the top of the freezer drawer 
appears satisfactory. 

6.  Tighten all washer-head screws (NOT SET SCREWS) 

firmly to secure brackets and adjustments in place. 
Start with bottom edge washer-head screws to 
provide support of the door panel. Next, moving on to 
top edge to prevent panel from moving from aligned 
position. Finish by tightening hinge side washer-head 
screws.  NOTE: Over-tightening washer-head screws 
may result in bending wood panel brackets as well as 
misaligning wood door 
panels. 

7.  Drive the door anchor 

screws through the 
two white plastic 
pockets in the side of 
each door and into 
the door panel (4 each 
door) to prevent panel 
warping over time.

Turn set screws on top and bottom 

of door to move panel up or down 

for desired gap with grille panel 

bottom.

1.  Replace trim and 4 screws on hinge side of the door.
2.  Replace handle visor trim and four screws on the 

handle side of the door.

3.  Replace trim cover and 4 screws over visor trim on the 

handle side of the door.

4.  Replace the visor trim and top cover to the top of the 

drawer using 4 screws.

5.  Replace the side brackets to each side of the drawer 

using 1 screw per side.

6.  Using 4 screws per side, replace the side trim to each 

side of the drawer.

Hinge Side 
Door Trim

Top Drawer 

Cover

Top 

Drawer 

Visor

Drawer Side 

Trim

Drawer 

Side 

Brackets

Handle 

Cover 

Trim

Handle Visor 

Trim