Perlick HA24FB31L Installation Instruction

PERLICK RESIDENTIAL INSTALLATION MANUAL

8

perlick.com

1.  Pull the shelf/drawer out to its furthest position. Locate 

the tabs in the middle of both extenders. Lift one tab up 

while pushing the opposite tab down, and pull shelf/

drawer out (Figure 6).

2.  Position each bracket separately. Grasp the middle of 

the bracket, pull the front end up and out, then forward 

to remove it.

3.  Place bracket at desired location. Push the bracket rear 

hook into the rear mounting slot, then set front of the 

bracket in the front slot.

4.  Repeat for other brackets.
5.  Push extenders completely into brackets. Align the 

shelf/drawer grooves with the extenders and slide 

completely into the unit.

Lift one tab on extender UP while

pushing tab on opposite extender DOWN

and pull out to remove.

To remove brackets,

remove shelf, lift front

of bracket to disengage

the front key slot, then

pull forward to disengage

the rear key slot.

Perlick residential units offer a variety of door panel design 

alternatives; solid stainless steel, solid wood overlay, glass 

with stainless steel trim and glass with wood overlay trim.

Solid stainless steel and stainless steel glass doors are 

shipped from the factory with decorative stainless steel 

panels and handles in place on the unit.  Solid wood overlay 

and glass wood overlay doors are designed to accept a 

decorative front panel to match surrounding cabinetry 

and door handles.

All Perlick units (excluding beer dispenser and ice maker 

models) accept any of the above door configurations and 

are fully interchangeable. Glass door configurations are not 

available on beer dispenser or ice maker models.

To change the door swing direction, a hinge kit is required:

•  Part No. 67439R - Right hinge kit
•  Part No. 67439L - Left hinge kit

In addition to the hinge kit, the following tools are required:

•  Large flat head screwdriver
•  Regular Phillips head screwdriver
•  Plastic putty knife

1). Support the door in the open position as shown in 

Fig. 7 on page 9. Remove the hinge pin.

2.) Pull door to the side and then lower door.

3.) Remove top and bottom hinge brackets. Retain screws 

for later use. See Fig. 8 on page 9.

4). Remove the hole plugs from the top and bottom hinge 

bracket mounting holes (see Fig. 8 on page 9). Place the 

plugs in the holes on the opposite side made vacant by 

removing the hinges in step 3.