Viking VCBB5363ERBU Installation Guide

Locate water filter door. The door is located under

the Adjustable Cold Zone™ handle.

Push upper left corner of door to release latch

and pull door downward.

Insert filter cartridge into circular opening in filter
housing. Rotate clockwise gently until filter stops.

Close water filter door.

Flush 3 gallons through filter before use (flush

approximately 3 minutes). If water spurts occur,

continue to run water until water runs steady.

Additional flushing may be required in areas with poor

quality water.

NOTE: Allow 1-2 minute delay in water dispersal to

allow internal water tank to fill.

Water Filter Installation

(Side-by-Side with Dispenser)

Water Filter System Specification and
Performance Data Sheet

This system has been tested according to NSF/ANSI 42/53 for reduction of the substances listed below. The
concentration of the indicated substances in water entering the system was reduced to a concentration of less than or
equal to the permissible limit for water leaving the system, as specified in NSF/ANSI 42/53.* (100% safety factors
built-in for unmetered usage for health claims only.)

*Based on the use of Cryptosporidium parvum oocysts

Operating Specifications

Capacity:

Certified for up to 750 gallons (2,838 L); up to nine months

Pressure Requirement:

20 - 120 psi (1.4 - 8.2 bar)

Temperature: 33-100

F (0.6 - 37.8

Flow rate:

0.78 gpm (2.9 l/min.)

Check for compliance with the state and local laws and regulations.

Note:

While the testing was performed under standard laboratory conditions, actual performance may vary.

Must be installed and operated in accordance with manufacturer’s recommended procedures and guidelines.
Installation instructions, parts and service availability, and standard warranty are included with the product when
shipped. This drinking water system must be maintained according to manufacturer’s instruction, including
replacement of filter cartridges.

Manufactured by:

3M Purification Inc.
400 Research
Parkway
Meriden, CT 06770

System tested and certified by NSF International
against Standard 42 for the reduction of chlorine
taste and odor, particulate Class I and Standard 53
for the reduction of Lead, Lindane, Atrazine, Mercury,
Toxaphene, Cyst, Turbidity, and Abestos.

Contaminant

Reduction

Average

Influent

NSF Specified

Challenge

Concentration

Avg %

Reduction

Average

Product Water

Concentrtation

Max Permissible

Product Water

Concentration

NSF

Reduction

Requirements

NSF Test

Report

Chlorine Taste and
Odor

2.0 mg/L

2.0 mg/L + 10%

97.5%

0.05 mg/L

N/A

> 50%

J-00056501

Nominal Particulate
Class I, >0.5 to <

1.0 µm

13,666,667

pts/mL

At least 10,000

particles/mL

98.9%

143,333 pts/mL

N/A

> 85%

J-00056506

Asbestos

96 MF/L

107 to 108 fibers/L;

fibers greater than

10µm in length

>99%

<1 MF/L

N/A

> 99%

J-00056511

Atrazine

0.010 mg/L 0.009 mg/L + 10%

89.3%

0.001 mg/L

0.003 mg/L

N/A

J-00056512

Cyst*

122,500

cysts/L

Minimum 50,000

cysts/L

99.99%

1 cyst/L

N/A

> 99.95%

J-00056513

Lead @ pH 6.5

0.153 mg/L 0.15 mg/L + 10%

99.3%

0.001 mg/L

0.010 mg/L

N/A

J-00056515

Lead @ pH 8.5

0.150 mg/L 0.15 mg/L + 10%

99.3%

0.001 mg/L

0.010 mg/L

N/A

J-00058784

Lindane

0.002 mg/L 0.002 mg/L + 10%

97.8%

0.00004 mg/L

0.0002 mg/L

N/A

J-00058969

Mercury @ pH 6.5

0.006 mg/L 0.006 mg/L + 10%

95.0%

0.0003 mg/L

0.002 mg/L

N/A

J-00058785

Mercury @ pH 8.5

0.006 mg/L 0.006 mg/L + 10%

88%

0.0007 mg/L

0.002 mg/L

N/A

J-00058783

Toxaphene

0.015 mg/L 0.015 mg/L + 10%

93.2%

0.001 mg/L

0.003 mg/L

N/A

J-00056531

Turbidity

10.8 NTU

11 + 1 NTU

98.7%

0.153 NTU

0.5 NTU

N/A

J-00058972