Viking VCRB5363RAR Installation Instruction

• Most of the unit’s weight is at the top.

Extra care is needed when moving the unit
to prevent tipping. 

• Do Not remove protective film until unit is

in operating position. 

• All four leveling legs must contact the floor

to support and stabilize the full weight. 

• Do not drop unit.

• Remove exterior shipping materials prior

to moving unit into home.

• Use two or more people to move and

install unit. Failure to follow this instruction
can result in back or other injury. 

• To avoid personal injury, wear gloves when

performing any installation procedure and
wear eye protection when cutting metal
straps.

Tip Over Hazard

Appliance is top heavy and tips easily when
not completely installed. Keep doors closed
until appliance is completely installed and
secured per installation instructions. Use two
or more people to move and install
appliance. Failure to do so can result in
death or serious injury.

Unpacking unit

1. Remove top and bottom strap.

2. Remove top cap.

3. Cut carton rear approximately 1/4” 

(0.6 cm) to 1” (2.5 cm) from right corner
with a utility knife extended 1/4” (0.6 cm).

4. Remove carton and exterior packaging.

Save cardboard shipping material to
protect floor surface when installing unit.
Remove anti-tip board, kickplate and door
trim pieces (DF models) from rear of unit.

34

Moving Unit

Remove shipping brackets from skid by removing 4 bolts

(2 on each side) with a 1/2” deep-well socket wench and

a pair of pliers.

Note: Tilting unit is not required to remove shipping

brackets. 

Slip appliance dolly between unit and skid. Only use
dolly from the rear of the unit to remove unit from skid.
After the unit is removed from the skid, a dolly can be
used from either side or the back BUT NOT THE FRONT.

Note: Use excess packaging to protect decorative trim;

also, verify that leveling legs are up (0” adjustment).

General Information