Viking VCBB5363ERCB Manual
30
31
Pr
oduct Car
e
Pr
oduct Car
oduct Car
e
Cleaning and Maintenance
Glass Shelves
To clean your refrigerator's glass shelves, lift the shelf out by
lifting the front and releasing the hooks from the metal track.
Then pull the shelf out. Be sure to allow the glass shelves to
adjust to room temperature before cleaning.
lifting the front and releasing the hooks from the metal track.
Then pull the shelf out. Be sure to allow the glass shelves to
adjust to room temperature before cleaning.
To clean crevices, dilute mild detergent with water. Brush this
solution into crevices using a plastic bristle brush. Let set for
five minutes. Spray warm water into crevices using faucet
spray attachment. Dry glass shelf thoroughly and replace shelf
by inserting hooks into metal track and lowering front.
solution into crevices using a plastic bristle brush. Let set for
five minutes. Spray warm water into crevices using faucet
spray attachment. Dry glass shelf thoroughly and replace shelf
by inserting hooks into metal track and lowering front.
Door Gaskets
Clean the door gaskets every three months using the same
procedures used for interior surfaces. You should apply a light
film of petroleum jelly to keep gaskets pliable.
procedures used for interior surfaces. You should apply a light
film of petroleum jelly to keep gaskets pliable.
CAUTION
To avoid personal injury or property damage, handle tempered glass
shelves carefully. Shelves may break suddenly if nicked, scratched, or
exposed to sudden temperature changes.
shelves carefully. Shelves may break suddenly if nicked, scratched, or
exposed to sudden temperature changes.
WARNING
ELECTRICAL SHOCK HAZARD
Disconnect power or turn power
disconnect switch to OFF position before
removing top grille. Failure to do so can
result in death or electrical shock.
disconnect switch to OFF position before
removing top grille. Failure to do so can
result in death or electrical shock.
WARNING
BURN HAZARD
Do not touch condenser coils near
defrost pan.
Doing so can result in burns.
defrost pan.
Doing so can result in burns.
Defrost Pan
To prevent condensation from overflowing, check defrost pan
periodically.
periodically.
To check defrost pan, remove two screws securing kickplate
to unit. Pull defrost pan forward until it stops. Remove any
excess water from pan. Wipe and clean defrost pan with a
sponge. Return defrost pan to original position. Return
kickplate to unit by securing with two screws.
to unit. Pull defrost pan forward until it stops. Remove any
excess water from pan. Wipe and clean defrost pan with a
sponge. Return defrost pan to original position. Return
kickplate to unit by securing with two screws.
Door Stop Adjustment
Your refrigerator is factory set at the 110° door stop position.
To change to either the 90° or 120° position, remove the
door stop pin using a 3/16” allen wrench.
To change to either the 90° or 120° position, remove the
door stop pin using a 3/16” allen wrench.
Cleaning and Maintenance
3
1
2
1
1
2
2
110˚
120˚
90˚
Open refrigerator door so door stop and
shoulder screw are accessible.
Remove shoulder screw and place in 90° or
120° position.
Side-by-Side