Lynx L42ASRNG Owner's Manual

31

the grill arrives nearly ready 

to use and requires only minor 

assembly. 
By carefully following the 

uncrating and unpacking 

steps, you will improve the 

customer’s first Lynx experi-

ence.
shipping weight on smaller 

units is app. 300 pounds and 

larger units may weigh over 

500 pounds.

 

do not remove staples 

around the top of the 

carton.  these staples 

hold a wooden pallet in 

place inside the carton 

that protects the unit from 

damage.  Removing these 

staples may cause the 

pallet to fall on the top of 

grill.

 

► cut the main strap holding 

the grill to the pallet.

 

► Remove the staples at the 

bottom of the carton.

 

► lift off the carton. 

 

► with assistance, remove 

the grill from the pallet and 

place into desired location. 

Use two or more people to 

move or install this unit. Fail-

ure to follow this instruction 

can result in back or other 

personal injuries.

the wheels sit down in the 

gaps of the shipping crate so 

that the grill can sit safely and 

solidly on the crate during 

shipping.  the grill cannot be 

slid directly off of the pallet.

one way to safely move the 

grill off of the pallet is by 

lifting one end of the grill 

high enough to place a ramp 

under  the wheel and then lift 

the other end while rolling the 

grill off of the pallet.

lynx uses sturdy tie-down 

cables and straps to ensure 

your grill arrives at your home 

in the same condition that 

it left our factory.  Be suRe 

you haVe RemoVed all 

tie downs BefoRe using 

youR gRill.

 

► Remove the white 

accessory box and wood 

packing, the grill racks, and 

remove any loose items 

from the firebox. 

 

► carefully cut the cable 

ties securing the warming 

Grill will not slide directly off pallet.

rack and rotisserie spit (if 

equipped). 

 

► cut the strapping that 

secures the briquette trays 

and carefully lift them out, 

front first.  

make sure you remember to 

remove the wire tie-downs on 

the burners

 

► on prosear™ 2 models, 

cut and remove ties from 

the burner partition on the 

left side of the prosear™ 2  

burner.

 

► ensure that all burners are 

properly seated on the 

burner valve orifice and 

sitting level with the legs 

in the frame slots and no 

side-to-side movement.