Thermador WDC30J Installation Instruction

4. Secure with three (3) 3/4” (3.175 mm) Phillips head 

screws (included).

5. Insert plug into three-prong, grounded outlet (see 

6. Slide warming drawer assembly into cutout until it is 

flush with cabinet. Take care that the side screws of 
the warming drawer do not scratch the cabinet. 

7. Drill pilot holes through side flange holes with a 1/8” 

(3.175 mm) wood bit.

8. Secure with four (4) stainless Phillips screws through 

9. Turn power on at the service panel.
10. Turn the warming drawer on. Indicator light and timer 

should turn on immediately. Close the drawer for 
approximately 30 seconds then check for warmth.

20⅝” (524 mm)

20⅝” 
(524 mm)