Lynx L36ASRLP Owner's Manual

3

1. Before each use, complete the checklist below
2. make sure all burner control knobs are in the “off” position
3. push and hold the control knob in for 2 – 5 seconds, allowing the igniter to heat up
4. tur

tt n the knob to the “lite” position

5. after ignition set the knob to the desired setting

1. Before each use, complete the checklist below
2. make sure all burner control knobs are in the “off” position
3. push and hold the control knob for 2 – 5 seconds
4. tur

tt n the knob to the “lite” position and continue to hold the knob in for an additional

30 – 60 seconds to allow the thermocouple to heat up and keep the safety valve open

…

Do you smell gas? If yes, shut off everything and call the gas company or a qualified plumber to 

Do you smell gas? If yes, shut of

Do you smell gas? If yes, shut of
check for leaks, if not please continue

…

are you prepared to stay with the grill during the entire cooking process? if not, gather what 
you need before starting the lighting process. if yes, please continue.

…

is your cooking area free and clear of any combustibles, besides your food, that might ignite? if 
no, clear the area before starting the lighting process, if yes, please continue

…

do all control knobs turn freely? if not, call for service, if yes, please continue.

…

if you are using a portable propane cylinder, is it connected and leak tested? if not, check the 
connection before continuing. if yes please continue.

…

do you know where your grill’s main gas supply shut off valve is located? if not, locate it before 
continuing. if yes, please continue.

…

are all burners properly seated in the grill with mounting legs in slots? if not, seat the burners 
properly before continuing. if yes please continue.

…

is the wind blowing just lightly and not blowing on the back of the grill? if not, wait until the 
wind subsides or turn your free standing grill so the wind goes into the front of the grill. if yes, 
please continue with the lighting process.