Lynx L30R1NG Installation Instruction

26

When lighting the grill for the first time or after switching LPG tanks it is necessary to purge the
gas train. 

Once the gas connection is complete check that all knobs are turned off.  (for LPG,   slowly open
the valve on the tank.)

Open the lid and turn the Rotiss. knob to lite and hold in the red IR Safety button, without press-
ing the ignition button, until you can detect the smell of gas. Release the      safety button and wait
a few minutes for the gas smell to clear.

Once again, hold in the red IR button and this time press the ignition button until the rotisserie
burner lights. Continue to hold the red button in for about 20 - 30 seconds at which point you can
release it and the burner should remain lit. This confirms the grill has been purged. Turn the
Rotisserie knob to the “off” position.

If the burner does not light after 4 seconds, turn the knob to off and wait 5 minutes before trying
again.

Turn the right burner knob to “Lite” and at the same time, push and hold the ignition     button. You
will hear a clicking sound as the burner electrodes spark. Keep the ignition     button depressed
until the burner is lit.

The IR main burners will normally take 2 to 3 minutes to glow red. Once that occurs adjust the
knob to the desired heat setting. 

Repeat this process for the other IR burner. If the burner does not light after 4 seconds, turn the
knob to off and wait 5 minutes before trying again.

If lighting the main IR burners in extremely cold conditions there may be a possibility of ‘burn back’.
Upon ignition, if you hear a ‘whooshing’ sound immediately turn the burner knob to off. This will
extinguish the burner.

Rev. 04/2005