Amana NGD5800DW Data Sheet

 

 

 

 

 

 

17.  Remove lint duct by removing the four (4) screws and clip 

as shown in Figure13.  

NOTE: Slide lint duct down and away from dryer to remove.

18.  Remove bulkhead assembly by first removing four (4) 

screws securing the bulkhead assembly to cabinet. 
Slightly lift up on bulkhead assembly and at the same 
time pulling away from drum working rollers off drum.  
See Figure 14.

NOTE: During removal of bulkhead, take special notice of the 
Lower Protective Shield to assure proper orientation during 
reassembly.

19.  Swing bulkhead assembly to side and remove two (2) 

harness  clips  to  disconnect  harness  from  bulkhead.                            
See Figure 15. 
NOTE: Only on models with the CCU Bracket  located on 
the right side of the unit.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

16.  Disconnect moisture sensor disconnect block from main 

harness disconnect block located at lower right side of 
dryer. See Figure 12.