Viking VCBB5363ELGG Installation Instruction
VIKING RANGE CORPORATION
111 Front Street • Greenwood, Mississippi 38930 USA • (662) 455-1200
Specifications subject to change without notice
For more product information, call 1-888-VIKING1 (845-4641), or visit our web site at www.vikingrange.com
F20235A EN
(030211 )
Figure 4
7. Using the panel hole locations as a template, drill ten (10) holes on the cabinet rear with a 9/64" (.36 cm) diameter
drill bit. (figure 3)
8. Attach the panel to the rear of the unit using the ten (10) black #8 sheet metal screws provided.
9. Plug unit into the receptacle and roll the unit so that the rear of the unit makes contact with the wall in the final
9. Plug unit into the receptacle and roll the unit so that the rear of the unit makes contact with the wall in the final
location.
10. Adjust to desired height, and level unit by turning the front and rear leveling wheel bolts clockwise to raise the unit
and counterclockwise to lower the unit. Rotate leveling feet until firmly in place against the floor. The unit back
should be tightly located against the back wall.
should be tightly located against the back wall.
11. Using the top panel rear flange as an attachment device, locate holes in the flange that are aligned with a
minimum of two wall studs. (figure 4)
12. Using wood screws that are a minimum of 1½" long, attach the top panel flange to the anchoring device (wall
studs or other mechanical device). Ensure that the screw heads will not pull through slots in top panel. Use
washer if necessary to prevent pull through.
washer if necessary to prevent pull through.
Screws
Wall
Studs
Figure 3
(Rear of unit)
Panel hole
locations
locations