Viking FDSB5423 Installation Guide

Page of 36
29
 
Water Filter System Specifi cation and Performance 
Data Sheet
 This system has been tested according to NSF/ANSI 42/53 for reduction of the substances listed 
below. The concentration of the indicated substances in water entering the system was reduced to a 
concentration of less than or equal to the permissible limit for water leaving the system, as specifi ed in 
NSF/ANSI 42/53.* (100% safety factors built-in for unmetered usage for health claims only.)
 
Contaminant
Reduction
  Average 
Infl uent
 
   NSF Specifi ed 
Challenge 
Concentration
   Avg % 
Reduction
 Average
Product Water 
Concentration
 Max Permissible 
Product Water 
Concentration
   NSF
Reduction
Requirements
 NSF Test
Report
 Chlorine Taste and 
Odor
 2.0 mg/L
 2.0 mg/L + 10%
 97.5%
 0.05 mg/L
 N/A
 > 50%
 J-00056501
 Nominal Particulate
Class I, >0.5 to <  
1.0 µm
 13,666,667 
pts/mL
At least 10,000 
particles/mL
98.9%
143,333 
pts/mL
N/A
> 85%
J-00056506
 Asbestos
 96 MF/L
10
7
 to 10
8
 fi bers/L; 
fi bers greater than 
10µm in length
>99%
<1 MF/L
N/A
> 99%
J-00056511
 Atrazine
 0.010 mg/L
0.009 mg/L + 10%
89.3%
0.001 mg/L
0.003 mg/L
N/A
J-00056512
 Cyst*
 122,500 
cysts/L
Minimum 50,000 
cysts/L
99.99%
1 cyst/L
N/A
> 99.95%
J-00056513
 Lead @ pH 6.5
 0.153 mg/L
0.15 mg/L + 10%
99.3%
0.001 mg/L
0.010 mg/L
N/A
J-00056515
 Lead @ pH 8.5
 0.150 mg/L
0.15 mg/L + 10%
99.3%
0.001 mg/L
0.010 mg/L
N/A
J-00058784
 Lindane
 0.002 mg/L
0.002 mg/L + 10%
97.8%
0.00004 mg/L
0.0002 mg/L
N/A
J-00058969
 Mercury @ pH 6.5
 0.006 mg/L
0.006 mg/L + 10%
95.0%
0.0003 mg/L
0.002 mg/L
N/A
J-00058785
 Mercury @ pH 8.5
 0.006 mg/L
0.006 mg/L + 10%
88%
0.0007 mg/L
0.002 mg/L
N/A
J-00058783
 Toxaphene
 0.015 mg/L
0.015 mg/L + 10%
93.2%
0.001 mg/L
0.003 mg/L
N/A
J-00056531
 Turbidity
 10.8 NTU
11 + 1 NTU
98.7%
0.153 NTU
0.5 NTU
N/A
J-00058972
 *Based on the use of Cryptosporidium parvum oocysts
Operating Specifi cations
 
Capacity:     
 
Certifi ed for up to 750 gallons (2,838 L); up to nine months
 
Pressure Requirement:   
20 - 120 psi (1.4 - 8.2 bar)
 
Temperature:  
 
33-100º F (0.6 - 37.8º C)
 
Flow rate:   
 
0.78 gpm (2.9 l/min.)
Check for compliance with the state and local laws and regulations.
Note: While the testing was performed under standard laboratory conditions, actual 
performance may vary.  
Must be installed and operated in accordance with manufacturer’s recommended procedures 
and guidelines. Installation instructions, parts and service availability, and standard warranty 
are included with the product when shipped. This drinking water system must be maintained 
according to manufacturer’s instruction, including replacement of fi lter cartridges.
 
Manufactured by:  3M Purifi cation Inc. 
 
 
 
400 Research Parkway   
 
 
Meriden, CT  06770
 
System tested and certifi ed by NSF International 
against Standard 42 for the reduction of chlorine 
taste and odor, particulate Class I and Standard 53 
for the reduction of Lead, Lindane, Atrazine, Mercury, 
Toxaphene, Cyst, Turbidity, and Asbestos.