Thermador HPWB48FS Manual
CARE AND CLEANING
The efficiency of the range hood system depends on the cleanliness of the intake and filters.
The frequency of cleaning depends on the amount and type of cooking.
• Do not use the ventilating system without the filters in place or with grease-laden filters or surfaces.
The frequency of cleaning depends on the amount and type of cooking.
• Do not use the ventilating system without the filters in place or with grease-laden filters or surfaces.
WARNING: To avoid risk of fire and explosion do not use flammable liquids or solvents.
Always unplug or disconnect the appliance from the power supply before servicing.
WARNING: Be sure the entire hood (including the filters and light bulbs) has cooled and grease has
solidified before attempting to clean any part of the appliance.
Always unplug or disconnect the appliance from the power supply before servicing.
WARNING: Be sure the entire hood (including the filters and light bulbs) has cooled and grease has
solidified before attempting to clean any part of the appliance.
Filters and drip trays
These hoods have reusable metal grease filters
and drip trays.
The metal filters also help prevent flaming foods
on the cooktop from damaging the inside of the
hood.
For this reason, the metal filters must ALWAYS
be in place when the hood is used.
and drip trays.
The metal filters also help prevent flaming foods
on the cooktop from damaging the inside of the
hood.
For this reason, the metal filters must ALWAYS
be in place when the hood is used.
To Clean Filters and Drip Trays
•The metal filters and drip trays should be
cleaned once a month, or as needed.
•To clean the metal filters and drip trays, drain
and wipe all excess grease with a dry paper
towel. Soak them and then swish them around
in hot water and detergent. Don’t use ammonia
or ammonia products because they will darken
the metal.
•Do not use abrasives or oven cleaners.
Rinse, shake and let them dry before replacing.
They may also be cleaned in an automatic
dishwasher.
towel. Soak them and then swish them around
in hot water and detergent. Don’t use ammonia
or ammonia products because they will darken
the metal.
•Do not use abrasives or oven cleaners.
Rinse, shake and let them dry before replacing.
They may also be cleaned in an automatic
dishwasher.
To Remove The Metal Grease Filters and the
Drip Trays
• Turn the fan and lights off.
• Push each handle towards the back and pull
downwards. Figure 1
• Unscrews the knobs that fix the drip trays
holding brakets. Figure 2
• Grasp the drip tray and carefully lift it up and
out of the hood track. Figure 2.
• Push each handle towards the back and pull
downwards. Figure 1
• Unscrews the knobs that fix the drip trays
holding brakets. Figure 2
• Grasp the drip tray and carefully lift it up and
out of the hood track. Figure 2.
To Replace The Metal Grease
• Reverse procedure.
To replace the Drip Trays
Figure 2-3:
1. Place and seat the drip tray into the hood track.
2. Slide them left or right until all trays are side
by side in place in the track.
3. Block firmly in place side drip trays with the
the drip trays holding brakets.
2. Slide them left or right until all trays are side
by side in place in the track.
3. Block firmly in place side drip trays with the
the drip trays holding brakets.
5
Figure 1
Figure 3
Figure 2