Monogram ZV36RSFSS Installation Instruction

1/4"

Gap

Original Mounting

Screws as Shipped

• Secure the wood support to 2 or more vertical studs, using

at least 2 of the 4 supplied long screws.

 Screws must penetrate at least 1-1/2" into

vertical studs. Countersink screws into support.

• Adjust depth of original mounting screws in wood support

until they protrude 1/4" forward. This 1/4" gap will provide
clearance to hang the hood.

Test  Duct Cover Fit
• Place duct cover(s) over the top of the hood to check for

gaps. Adjust the hood up or down if necessary.

Install Bottom Mounting Screws
• Drill 1/8" pilot holes into the two bottom mounting holes.

Enlarge the holes if they did not enter studs to 3/8". Insert
anchors for wall fasteners into bottom holes. Remove
anchor screws and add flat washers provided. Drive
screws into anchors and tighten.

• Install 4 additional screws through the inside back of the

hood and into the wood support.

IMPORTANT: Remove
shipping tape from
damper and check that
damper moves freely.

• Locate at least 2 vertical studs at the wood support.
• Center the supplied wood support, left to right and below the

20" marked line.

• Place the duct transition piece over the hood exhaust and secure

with 4 screws provided.

• Use duct tape to seal the connection. Check to be sure the

damper moves freely.

Hang Hood On Wood Support
• Lift the hood and hold close to the installation location. Route

house wiring through the knockout and into the junction box.

• Place the hood over the wood support. Be sure the mounting

screws engage the keyhole slots in the back of the hood. Tighten
the screws.

Continue to provide additional

support while the hood is mounted with only these 2 screws. These
screws will not support the weight of the hood. The hood could
fall resulting in damage or personal injury.

 Continuez à fournir un

soutien additionnel pendant le montage de la hotte avec ces deux
vis seulement. Ces deux vis ne soutiendront pas le poids de la
hotte. La hotte peut tomber, occasionnant des blessures
corporelles ou des dommages matériels.
• Check to be sure the hood is level and centered.

Duct

Transition

Top of

Hood

Centerline of 
Installation
Space

20"

Bottom

of

Hood

Wood
Support

Centerline of 
Installation
Space

Bottom

Mounting

Holes

30"

to

36"

Note: The mounting
screws must remain in
their original shipping
location. These screws
are positioned to engage
the keyhole slots in the
back of the hood.