Monogram ZFSB25DXSS Installation Instruction

When connecting a GE Reverse Osmosis Water System 
to your refrigerator, the GE RVKit must be used. For 
other reverse osmosis water systems, follow the 
manufacturer’s recommendations.

If the water supply to the refrigerator is from a Reverse
Osmosis Water System, use the refrigerator’s filter
bypass plug. Using the refrigerator’s water filtration 
cartridge with the RO filter can result in hollow ice cubes
and slower water flow from the water dispenser.

Turn left to remove

Turn right to install bypass plug

213Dia8

Check to be sure that refrigerator power cord is not
plugged into the wall outlet.

If you are using copper tubing:
• Place compression nut and ferrule (sleeve) onto 

the end of the tubing coming from the house water
supply.

• Insert the end of the copper tubing into the 

refrigerator connection at the back of the 
refrigerator, as far as possible. Hold the tubing 
in place and tighten the fitting.

• Insert the molded end of the tubing into the 

refrigerator connection, at the back of the 
refrigerator, and tighten the compression nut 
until it is hand tight.

• Then tighten one additional turn with a wrench.

Overtightening may cause leaks.

• Fasten the tubing into the clamp provided to hold it 

in position. You may need to pry open the clamp.

• Turn on the water at the shut-off valve to check 

for leaks.

• Connect refrigerator power cord plug to a properly

grounded receptacle. 

• Check to make sure power to refrigerator is on by

opening refrigerator door to see if interior lights 
are on.

1/4" Tubing

Tubing Clamp

1/4"
Compression Nut

Ferrule 
(sleeve)

SmartConnect™ Tubing

Refrigerator Connection

• Remove outside protective wrapping.
• Move the refrigerator into final installation position.
• Remove door spacer and all inside packaging.