BlueStar PRZIDCB30V2 Owner's Manual

                                   P/N 750301 Page   14 

 

All specifications are subject to change without prior notification 

BACKGUARD 
All charbroilers require a backguard.  The 
IDCB30 gives you the option of  using an is-
land trim; 7 inch standard; 17 inch hi-back; 24 
inch high shelf.  IDCB15 comes with the op-
tion of an island trim or 7 inch backguard. 
 
If you are using an island trim, a six inch 
clearance between the back of the range and a 
combustible surface is required.  If an island 
trim is to be used without this six inch clear-
ance, the back wall must be non-combustible 
and heat resistant material that extends below 
the top surface of the range a minimum of six 
inches. 
 
All backguards follow the same basic installa-
tion.  Using hardware supplied, align the  
backguard with the wrap around on each side 

and slip the tongue into place.  A minimum of 
six sheet metal screws (more depending on 
width) are to be installed, three on each end 
and more along the bottom edge. 
 
Remove the charbroiler grates from the cook-
top surface.  Four sheet metal screws to be 
installed - down -  into the cooktop support.  
Two screws are installed on each end ring 
grate/top grate position.  Replace the removed 
grates. 
 
If you are installing a high shelf, there is an 
additional channel to be installed on each side 
first.  The back guard then slips over this 
channel as you put it into position.  This chan-
nel provides extra support for the higher rise 
of the 24 inch back.