KitchenAid KVWB600DBS Use & Care Manual
11
Install Vent Covers
When using both upper and lower vent covers, push lower
cover down onto hood and lift upper cover to ceiling and
install with (2) 4.2 x 8 mm screws.
cover down onto hood and lift upper cover to ceiling and
install with (2) 4.2 x 8 mm screws.
NOTE: For vented installations the upper vent cover may
be reversed to hide slots.
be reversed to hide slots.
Secure the bottom of the duct with (2) 4.2 x 8 mm screws.
Complete Installation
1. For non-vented (recirculating) installations only, install
charcoal filters over grille on blower housing. See the
“Range Hood Care” section.
“Range Hood Care” section.
2. Install metal filters. See the “Range Hood Care” section.
3. Check the operation of the range hood blower and light.
See the “Range Hood Use” section.
NOTE: To get the most efficient use from your new range hood,
read the “Range Hood Use” section.
read the “Range Hood Use” section.
RANGE HOOD USE
The range hood is designed to remove smoke, cooking vapors and
odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the kitchen.
odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the kitchen.
The range hood controls are located on the front side of the
canopy.
canopy.
Control Panel
Controls and Features
NOTES:
■
To activate the controls, press and release the desired button.
■
The control feature touch will be lit when a control feature
is turned On.
is turned On.
Sleep Mode
The range hood automatically enters Sleep Mode when not
in use. After 10 minutes of no range hood activity, all of the
control button lights will turn Off. To deactivate Sleep Mode,
press any button.
in use. After 10 minutes of no range hood activity, all of the
control button lights will turn Off. To deactivate Sleep Mode,
press any button.
Auto Sense
Auto Sense allows the range hood fan to turn on automatically
when it senses heat higher than its allowable temperature limit.
When Auto Sense is On, the fan speed will increase or decrease
based on the temperature Auto Sense is measuring.
when it senses heat higher than its allowable temperature limit.
When Auto Sense is On, the fan speed will increase or decrease
based on the temperature Auto Sense is measuring.
Auto Sense can be manually increased by pressing a higher
fan speed. The fan will run at the selected speed for 10 minutes
before returning to the speed selected for Auto Sense.
fan speed. The fan will run at the selected speed for 10 minutes
before returning to the speed selected for Auto Sense.
If Auto Sense is On, the Auto button light will turn Off and go
into Sleep Mode when the vent hood is not in use. If the vent
hood is turned On by the consumer or by Auto Sense, the
Auto button light will turn On.
into Sleep Mode when the vent hood is not in use. If the vent
hood is turned On by the consumer or by Auto Sense, the
Auto button light will turn On.
A. Upper vent cover
B. Lower vent cover
B. Lower vent cover
C. 4.2 x 8 mm screws
D. Bracket
D. Bracket
A
B
C
D
A. Louver holes (non-vented
[recirculating] installations only)
B. Duct covers
C. LED lights (2)
D. Perimetric cover
D. Perimetric cover
E. Metal grease filters (located
behind the perimetric cover)
F. Canopy
G. Halogen light
H. Control panel
A
B
C
D
E
F
G
H