KitchenAid KFIS29BBMS-SS Owner's Manual

FILTERS AND ACCESSORIES

■

Continue to turn the alignment screw until the doors are 
aligned. 

6. Make sure the refrigerator is steady. If the refrigerator seems 

unsteady or rolls forward when the door or drawer is pulled 
open, adjust the brake feet.

■

Open the freezer drawer. Using a 

¹⁄₄" hex driver, turn both 

brake feet clockwise the same amount until the brake feet 
are snug against the floor. Check again. If not satisfied, 
continue to adjust the brake feet by half turns of the 
screw until the refrigerator does not roll forward when the 
drawer is opened. 

NOTE: Having someone push against the top of the 
refrigerator takes some weight off the brake feet. This 
makes it easier to turn the screws.

7. Replace the base grille by aligning the ends of the grille with 

the leveling assemblies on each side and snapping the grille 
into place.

1. Locate the accessory packet in the refrigerator and remove 

the water filter. 

2. Take the water filter out of its packaging and remove the 

cover from the O-rings. Be sure the O-rings are still in place 
after the cover is removed.

3. The water filter compartment is located in the right-hand side 

of the refrigerator ceiling. Push up on the compartment door 
to release the catch, then lower the door. 

4. Align the arrow on the water filter label with the cutout notch 

in the filter housing and insert the filter into the housing.

¹⁄₈

A

B

Do not use with water that is microbiologically unsafe or 
of unknown quality without adequate disinfection before 
or after the system. Systems certified for cyst reduction 
may be used on disinfected waters that may contain 
filterable cysts.

A