Haier HF50CM23NW Owner's Manual

English

1.  Remove all packaging material. This includes the foam base and all 

adhesive tape holding the freezer accessories inside and 

outside. 

2.  Inspect and remove any remains of packing, tape or printed 

materials before powering on the freezer.

Risk of Fire or Explosion due to puncture of refrigerant tubing. 

Flammable refrigerant used. Handle with care when moving freezer to 

avoid either damaging the refrigerant tubing or increasing the risk of a 

leak.

•  Your freezer is designed for freestanding installation only.  

It should not be recessed or built-in.

• Place the freezer on a floor strong enough to support it fully loaded.

•  When moving the freezer, never tilt it more than a 45-degree angle. 

This could damage the compressor and the sealed system. 

•  If the freezer is tilted let it stand in an upright position for at least 24 

hours prior to plugging. This is to allow the refrigerant to settle.

•  To assure your freezer works at the maximum efficiency it  

 

was designed for, you should install it in a location where there  

is proper air circulation, plumbing and electrical connections.

•               The following are recommended clearances around the freezer:

    Sides……………4” (102mm)

   Back..................4” (102mm) 

   Top....................Do not block