APC SUVTP10KH2B2S User Manual
3
Sea packaging.
Stabilizing Brackets
Attach stabilizing brackets
Caution: After unpacking always install the stabilizing
bracket (shipped with the UPS) to the 352 mm (13.85 in)
enclosure.
bracket (shipped with the UPS) to the 352 mm (13.85 in)
enclosure.
Note: This equipment is easily tipped. Use extreme caution
when unpacking and moving the equipment to its final
location.
when unpacking and moving the equipment to its final
location.
Use the screws (which attached the transport brackets to the UPS) to
fasten the stabilizing bracket to the UPS.
Move the UPS with stabilizing brackets
Loosen the screws, push the brackets upwards and tighten the screws.
Push the brackets downwards when the UPS is at its final position and
tighten the screws.
Cut carefully along the
edges to remove the plastic
and to free the ramp.
and to free the ramp.
Place the ramp by aligning
the velcro strips on the ramp
with the velcro strips on the
front edge of the pallet.
with the velcro strips on the
front edge of the pallet.
Remove the cardboard
cover.
Cut along the edges of the
cardboard cover and remove
it.
it.
Remove the corner
protection and the plastic
bag.
bag.
Remove the bolts from the
brackets attaching the
enclosure to the pallet and
save the brackets for floor
anchoring, if required.
enclosure to the pallet and
save the brackets for floor
anchoring, if required.
Roll the unit off the pallet.
Ramp