Electrolux EI24BC10QS Owner's Manual

9

Starting your appliance:
Plug the appliance power cord into a 115 

volt wall outlet. Your appliance is shipped 

from the factory in the "On" position and 

will begin start-up of cooling as soon as 

power is supplied. If the appliance does 

not start, confirm that the wall outlet has 

power, and that the control is in the "On" 

position, (See "Turning your appliance On 

and Off"). 
The control display is covered with a clear 

plastic film. This film may be removed by 

carefully lifting the film at a corner.
On initial power up, the control display will 

indicate a "Power Failure" alarm. This is 

a normal condition as the appliance was 

powered-up at the factory for quality inspection 

and then removed from power. A momentary 

press of the "On/Off" keypad will reset this 

alarm condition. (See Alarms section).

Sleep mode:
If no keypads are pressed for 60 seconds, 

the display will enter sleep mode to 

conserve power. The control panel will 

go dark with the exception of the system 

status "OK" indicator which will remain 

enabled. Alarm conditions will wake the 

display, (see Alarms section).
To make the following changes to the 

control settings (turning the appliance ON/

OFF, adjusting the temperature, changing 

the interior lights, and activating vacation 

mode), the control must be awake. 

Turning your appliance ON and OFF:
If the appliance is "On", (and out of sleep 

mode) the temperature will be shown in 

the display area of the control. To turn the 

appliance "Off", press and hold the "On/

Off" keypad for four seconds. "OFF" will 

now be displayed on the control.

The sleep mode can be disabled if you 

prefer to have the display on continuously. 

Press and hold the "Lock" keypad until the 

display goes past "Loc" and reads "nSL". 

To enable the sleep mode, repeat the 

instruction, again going past "Loc" until the 

display reads "SLP".

To wake the display press any keypad. A 

confirm tone will sound, and the current 

storage compartment temperature will be 

displayed. 

Figure 8

Electronic Control Display

To turn the appliance "On", press and hold 

the "On/Off" keypad for four seconds.

alarm reset

temp

power failure

air filter

door ajar

alarm reset