Philips AZ127/05 Quick Setup Guide
www.philips.com/welcome
Always there to help you
Register your product and get support at
Question?
Contact
Philips
2014 © WOOX Innovations Limited. All rights reserved.
Philips and the Philips’ Shield Emblem are registered trademarks
of Koninklijke Philips N.V. and are used by WOOX Innovations
Limited under license from Koninklijke Philips N.V.
AZ127_05_Short User Manual_V4.1
Short User Manual
AZ127
DBB
Search within play.
Press to open the tape door.
Pause.
Start to play.
1
In CD mode, press to stop playback.
2
Press
PROG
to activate programming.
3
Press repeatedly to select a track, then press
PROG
to confirm.
4
Repeat steps 3 to program more tracks.
5
Press to play the programmed tracks.
6
To cancel the program, press twice.
*
In CD mode, the unit switches to standby mode automatically if there is
no audio signal detected for over 15 minutes.
PROG
SHUFFLE
REPEAT
PROG
SHUFFLE
REPEAT
Skip to the previous/next track or search within play.
Stop play or erase a program.
Program the play sequence of tracks.
Play a track or all tracks repeatedly.
Turn on/off the unit.
Play tracks randomly.
Pause or start play.
Program tracks
*
In CD/AUDIO IN/FM mode, press to wake up your speaker from
standby mode.
Short User Manual
www.philips.com/welcome
Always there to help you
Register your product and get support at
Question?
Contact
Philips
Before using your product, read all accompanying safety information.
6X1.5V R14/UM2/C CELL
To play with the device, you can use either alkaline battery (R14) or AC power.
There are no messages show in the display panel in FM/AUDIO IN/TAPE/CD mode.
Make sure that all the buttons are ejected when you close the tape
door with a tape inside.
AC~MAINS