Toshiba P30 Series User Manual

User’s Manual

3-10

Getting Started

Data save in hibernation mode

When you turn off the power in hibernation mode, the computer takes a

moment to save current memory data to the hard disk. During this time, the

Built-in HDD indicator will light.
After you turn off the computer and memory is saved to the hard disk, turn

off the power to any peripheral devices.

Standby mode

In standby mode the power remains on, but the CPU and all other devices

are in sleep mode.

Standby precautions

■

Before entering Standby mode, be sure to save your data.

■

Do not remove/install memory or remove power components:

■

Do not remove/install the memory module. The computer or the

module could be damaged.

■

Do not remove the Battery Pack.

In any of the above cases, the standby configuration will not be saved.

■

If you carry the computer on board an aircraft or into a hospital, be sure

to shut down the computer in hibernation mode or in shutdown mode to

avoid radio signal interference.

Do not turn the computer or devices back on immediately. Wait a moment

to let all capacitors fully discharge.

■

If the computer is not used or accessed in any way, including receipt of

e-mail, for 15 or 30 minutes when the AC adaptor is connected, the

computer will automatically enter Standby mode (TOSHIBA Power

Saver default).

■

To restore operation, press the power button.

■

If a network application is active when the computer automatically

enters Standby, it might not be restored when the computer wakes up

from standby. To prevent the computer from automatically entering

standby mode, disable Standby in the TOSHIBA Power Saver. Open

the TOSHIBA Power Saver and click the Power Save Modes tab. Next

select either an AC Power or Battery Power option and then click

details. When the details page comes up, you can disable the Standy

setting be moving the slider to Never. That action, however, will nullify

the computer's Energy Star compliance.