GE HE500TIU050 User Manual

CH. 9: SMARTSTACK 06 Apr 2000 PAGE 43

GFK-1819

CHAPTER 9: SMARTSTACK



9.1 Scope
Horner has now added the SmartStack



modules from the OCS Range to the TIU20X range. The

SmartStack system is a method of allowing I/O expansion on an HMI. A wide range of modules is
available including Digital and Analogue.

9.2

Installing and Removing a SmartStack Module

The following section describes how to install and remove a SmartStack Module.

Caution: To function properly and avoid possible damage, do not install more than four
Smart Stack



Modules per TIU20X.

9.2.1

Installing SmartStack Modules

1. Hook the tabs. Each SmartStack Module has two tabs that fit into slots located on the TIU20X. (The

slots on the TIU20X are located on the back cover.)

2. Press the SmartStack Module into the “locked” position, making sure to align the SmartStack Module

fasteners with the SmartStack receptacles on the TIU20X.

9.2.2

Removing SmartStack Modules

1. Using a Flathead screwdriver, pry up the end of the SmartStack Module (opposite of tabs) and swing

the module out.

2. Lift out the tabs of the module.

Figure 9.1 – Installing a SmartStack



Module in an OCS.