Gaggenau RB 492 User Manual

6

These mounting instructions are designed to help you 

install your new appliance.
The manufacturer cannot be held liable for mounting 

which has been improperly carried out. We recommend 

that you allow a qualified specialist to set up and switch 

the appliance on for the first time.
Following all information and keeping to the instructions 

are preconditions for mounting and switching the 

appliance on safely for the first time.
Keep the mounting instructions safe for use later on.
Before setting up and switching the appliance on for the 

first time, read the mounting instructions fully and 

thoroughly. 

ã WARNING

These appliances are top-heavy and must be 

secured to prevent the possibility of tipping forward. 
Anti-tip protection is required.
Keep doors closed until the appliance is completely 

installed and secured per installation instructions.
Due to the weight and size of this appliance, and to 

reduce the risk of personal injury or damage to the 

product – TWO PEOPLE ARE REQUIRED FOR 

PROPER INSTALLATION.
This appliance must be properly grounded. See the 

section on “Connecting the power”.
Use this appliance only for its intended purpose.
Immediately repair or replace electric service cords 

that become frayed or damaged.
Unplug the appliance or switch off the fuse before 

cleaning or making repairs.
Repairs should be made by a qualified service 

technician.

ã CAUTION

Installation of this appliance requires basic 

mechanical, carpentry and plumbing skills. 
Proper installation is the responsibility of the 

installer.
Product failure due to improper installation is not 

covered under the Appliance Warranty. 
See the Owner's Manual for warranty information.

Save these instructions for local inspector's use. 

Observe all governing codes and ordinances.
Note to Installer – Be sure to leave these instructions 

with the Consumer.
Note to Consumer – Keep these instructions with your 

Owner's Manual for future reference.

These installation instructions are intended for use by 

qualified installers. All connections for water, electrical 

power and grounding must comply with local codes and 

ordinances and be made by licensed personnel when 

required. In the absence of a local code:
–

In the U.S.A., in accordance with the National 

Electric Code, ANSI/NFPA70 – latest edition/State 

and Municipal codes and/or local codes.

–

In Canada, in accordance with the Canadian Electric 

Code C22.1 – latest edition/Provincial and 

Municipal codes and/or local codes.

ã

This indicates that death or serious injuries may 
occur as a result of not observing this warning.

ã

This indicates that minor or moderate injuries or 
damage may occur as a result of not observing 
this warning.

Note:
This  is used to draw the user's attention to something in 

particular.