GE JS905 Installation Instruction
1
MATERIALS YOU MAY NEED
3-Wire Cord
4
’
long
(UL Approved 40 or 50 AMP)
Lag Bolts
Anchor Sleeves
(For Anti-Tip Bracket Mounted
on Concrete Floors Only)
4-Wire Cord
4
’
long
OR
If you have questions, call 1.800.GE.CARES or visit our website at:
ge.com
ge.com
Self-Cleaning Radiant
Electric Slide-In Range
Electric Slide-In Range
Installation
Instructions
Instructions
JSP42, JS968, JS900, JS905, JSP46
31-10621-3
09-08 JR
Before You Begin
Read these instructions carefully and completely.
•
IMPORTANT
—Save these
instructions for local inspector’s use.
•
IMPORTANT
—Observe all
governing codes and ordinances.
• Note to Installer—Be sure to leave these
instructions with the consumer.
• Note to Consumer—Keep these
instructions for future reference.
• Proper installation is the responsibility
of the installer and product failure due
to improper installation is NOT covered
under warranty.
to improper installation is NOT covered
under warranty.
• NOTE—This appliance must be properly
grounded.
PARTS INCLUDED
Anti-Tip Bracket
Screws
Rear Filler
2 Screws
2 Screws
TOOLS YOU WILL NEED
1/8
”
Drill Bit and
Electric or Hand Drill
1/4
”
Nut Driver
Level
Tape Measure
Straight Edge
or Square
or Square
Hand or Sabre Saw
Pencil
Safety Glasses
Wrench or Pliers
(for 1-7/16
(for 1-7/16
”
Nut)
Pliers
Tin Snips
Squeeze Connector
(For Conduit
Installations Only)