Viking VWC11150GRSS User Manual
15
14
Winterizing Outdoor Units
This process should occur when the daily low temperature is at
or below the set point temperature in the unit.
or below the set point temperature in the unit.
1.
Turn unit to OFF position by pressing the OFF button
on the controller. The controller displays the word OFF
(If power cord is accessible, unplug the cabinet. If not,
turn off the circuit breaker to the receptacle the cabinet
is plugged into.)
on the controller. The controller displays the word OFF
(If power cord is accessible, unplug the cabinet. If not,
turn off the circuit breaker to the receptacle the cabinet
is plugged into.)
2.
Remove all contents from the unit.
3.
Remove the kickplate from the unit.
4.
Clean the condensor by using a vacuum cleaner
to remove the loose debris (dirt, leaves, etc.) that may
have gotten inside the kickplate.
to remove the loose debris (dirt, leaves, etc.) that may
have gotten inside the kickplate.
5.
Reattach the kickplate.
6.
Clean the interior using Stainless Steel Cleaner and
Polish.
Polish.
7.
Clean the exterior using Stainless Steel Cleaner and
Polish.
Polish.
NOTE: Do not place a cover over the unit.
NOTE: While not required, you may choose to remove the unit
from the outdoor location and store indoors.
from the outdoor location and store indoors.
WARNING
Leaving your product operating in temperatures lower than those
recommended will void the warranty.
recommended will void the warranty.
This process should occur when the daily low temperature is at
or above the set point temperature in the unit.
or above the set point temperature in the unit.
1.
Plug the unit into the electrical receptacle.
2.
Press the OFF button one time to turn the unit ON. The
controller will read the actual temperature inside the
unit on the display. It will soon begin the cooling
process to bring the unit to the set temperature.
controller will read the actual temperature inside the
unit on the display. It will soon begin the cooling
process to bring the unit to the set temperature.
3.
Remove the kickplate from the unit.
4.
Check the condensing unit to ensure it is clear of loose
debris, clean as necessary with vacuum cleaner.
debris, clean as necessary with vacuum cleaner.
5.
Reattach the kickplate to the unit.
6.
Clean the interior using Stainless Steel Cleaner and
Polish.
Polish.
7.
Clean the exterior using Stainless Steel Cleaner and
Polish.
Polish.
Preparing for Spring Use