Viking W10345054 User Manual
19
Water & Ice Dispenser
(cont.)
O
p
e
ra
tio
n
18
Dispense Ice and Water
(cont.)
1. Select either water or cubed ice by touching “WATER” or “ICE” on
the control panel. The light above the control indicates your
selection.
selection.
2. Press a sturdy container against the dispenser lever.
IMPORTANT: You do not need to apply a lot of pressure to the
lever in order to activate the dispenser. Pressing hard will not make
the water or ice dispense faster or in greater quantities.
lever in order to activate the dispenser. Pressing hard will not make
the water or ice dispense faster or in greater quantities.
3. Remove the container to stop dispensing.
Dispenser Light
• The dispenser lights are LEDs which should
not need to be changed.
• When you use the dispenser, the lever will
automatically turn the light on. If you want
the light to be on continuously, you may
choose either ON or AUTO.
the light to be on continuously, you may
choose either ON or AUTO.
Auto: The light sensor monitors the light level in the room. The
dispenser light will illuminate at half-power when the light level is low.
To activate the Auto option press the “LIGHT” touch pad. The Auto
indicator light will illuminate.
dispenser light will illuminate at half-power when the light level is low.
To activate the Auto option press the “LIGHT” touch pad. The Auto
indicator light will illuminate.
On: For continuous light, press the “LIGHT” touch pad a second time.
The ON indicator light will illuminate.
The ON indicator light will illuminate.
Off: To turn the dispenser light OFF, press the “LIGHT” touch pad a
third time.
third time.
Dispenser Lock
The dispenser can be locked for easy cleaning or to avoid
unintentional dispensing by small children and pets.
unintentional dispensing by small children and pets.
Note: The dispenser lock does not shut off power to the product, to
the ice maker, or to the dispenser light. It just deactivates the
dispenser lever.
the ice maker, or to the dispenser light. It just deactivates the
dispenser lever.
Water & Ice Dispenser
(cont.)
O
p
e
ra
ti
o
n
To Lock and Unlock Dispenser:
Press and hold the “LOCKED” touch pad for three
seconds to lock the dispenser. The indicator light will
illuminate when Lock is on.
Press and hold the “LOCKED” touch pad for three
seconds to lock the dispenser. The indicator light will
illuminate when Lock is on.
Press and hold the “LOCKED” touch pad again for three
seconds to unlock dispenser. The indicator light will turn OFF.
seconds to unlock dispenser. The indicator light will turn OFF.
Water Filtration System
The water filter is located in the upper right-hand corner of the
refrigerator compartment.
refrigerator compartment.
Note:
DO NOT use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after the system.
Systems certified for cyst reduction may be used on disinfected waters that
may contain filterable cysts.
Systems certified for cyst reduction may be used on disinfected waters that
may contain filterable cysts.
Water Filter Status
The control panel will remind you when it is time to order and replace
your water filter by displaying a message when you dispense water.
ORDER WATER FILTER means it is almost time to change the water
filter and REPLACE WATER FILTER means a new water filter should be
installed. It is recommended that you replace the water filter when you
see the REPLACE WATER FILTER message OR earlier if the flow of
water to your water dispenser or ice maker decreases noticeably.
your water filter by displaying a message when you dispense water.
ORDER WATER FILTER means it is almost time to change the water
filter and REPLACE WATER FILTER means a new water filter should be
installed. It is recommended that you replace the water filter when you
see the REPLACE WATER FILTER message OR earlier if the flow of
water to your water dispenser or ice maker decreases noticeably.
Reset Water Filter Status
After replacing the water filter, you must reset the water filter
status to turn off the message.
status to turn off the message.
1. On main menu, press the touch pad next to “OPTIONS”.
2. In each of the following screens, continue to press the touch pad
2. In each of the following screens, continue to press the touch pad
next to “MORE OPTIONS” until you reach the “REPLACE FILTER”
screen.
screen.
3. Press the touch pad next to “YES” to reset the water filter status.
Press the touch pad next to “NO” if you do not wish to reset the
water filter status.
water filter status.