U-Line 2175WCOL2 User Manual

Your Wine Captain has been designed to provide three 
temperature zones within the cabinet so the specific 
storage requirements of your finest wines can be satisfied. 
NOTE: These are product temperatures, not air 
temperatures.

The electronic control with digital display (Figure 4) is 
configured to show a single temperature continuously. 
This set-point temperature is a base number used by the 
controller to maintain the temperature zones in your unit. 
The factory default set-point temperature is 50°F. This set-
point temperature is used as a gauge if further 
temperature adjustments are required.

A DISPLAY OFF mode is available through the control 
panel. This mode allows you to control whether the 
display (Figure 4, 3) will be ON or OFF whenever the 
door is closed. The icon touch sequence that follows will 
switch between both modes:

1. Touch and hold the WARMER icon (Figure 4, 2), and 

within five seconds press the POWER icon (Figure 
4, 1) three times.

2. The display will be either visible or dark when the door 

is closed.

3. To return to the previous mode, repeat Step 1. 

U-Line products supplied for 110 VAC operation have 
temperatures displayed in a default Fahrenheit (°F) 
configuration (Figure 4, 3). Models supplied for 220 VAC 
operation have temperatures displayed in a default 
Celsius (°C) configuration.

The display can easily be adjusted for either type of 
temperature display. Press and hold the LIGHT icon 
(Figure 4, 5) and within five seconds press the COOLER 
icon (Figure 4, 4) three times to change the display as 
desired.

To display all zone temperatures:

1. Press and hold the WARMER icon (Figure 4, 2) for 

approximately five seconds and release when the °F 
symbol in the display (Figure 4, 3) begins to flash.

2. The display (Figure 4, 3) will scroll through three 

individual readings at two second intervals per 
temperature.

3. The °F symbol in the display will indicate the individual 

zone temperature being displayed as they are scrolling.

• The top horizontal bar in the symbol indicates the 

upper cabinet zone.

• The middle horizontal bar in the symbol indicates 

the middle cabinet zone.

• The bottom horizontal bar in the symbol indicates 

the lower cabinet zone. 

4. After the third scroll cycle is completed, the display will 

return to the set-point temperature. 

To adjust the set-point temperature:

1. Press and release either the WARMER icon (Figure 

5, 2) or COOLER icon (Figure 5, 4) to put the 
controller in the SET TEMPERATURE mode. The °F 
symbol (Figure 5, 3) will begin to flash.

NOTE: If no further action is taken, this mode will self 
cancel in five seconds, and the original set-point 
temperature will be displayed.

2. While the °F symbol is flashing, press the WARMER or 

COOLER icon as required to adjust the set-point 
temperature.

3. The change will be set five seconds after adjusting the 

temperature and the new set-point temperature will be 
displayed.

All models incorporate rigid foam insulated cabinets to 
provide high thermal efficiency and maximum sound 
reduction for its internal working components. In spite of 
this technology, your model may make sounds that are 
unfamiliar. 

Normal operating sounds may be more noticeable 
because of the unit’s environment. Hard surfaces such as 
cabinets, wood/vinyl/tiled floors and paneled walls have a 
tendency to reflect normal appliance operating noises.

ULIN_0184_A

ULIN_0184_A