KitchenAid KSSS36QKB01 User Manual
5
To replace top grille:
1.
Insert top grille hooks (located on the back of the top grille)
into the slots on the side trim.
into the slots on the side trim.
2.
Pull grille down slightly to lock into place.
Wraparound Door Models (on some models)
To remove top grille:
1.
Grasp both ends of louver panel. Push louver panel straight
up, then pull straight out. Lay the panel on a soft surface.
up, then pull straight out. Lay the panel on a soft surface.
2.
Grasp both ends of the top grille. Push top grille straight up,
then pull straight out. Lay the top grille on a soft surface.
then pull straight out. Lay the top grille on a soft surface.
To replace top grille:
1.
Insert top grille hooks (located on the back of the top grille
panel) into the slots on side trim. Pull grille down slightly to
lock into place.
panel) into the slots on side trim. Pull grille down slightly to
lock into place.
2.
Insert louver panel hooks (located on the back of the louver
panel) into the slots on the side trim. Pull panel down slightly
to lock into place.
panel) into the slots on the side trim. Pull panel down slightly
to lock into place.
To Turn Power On or Off:
1.
Remove top grille.
2.
Press main power switch to the ON or OFF position.
3.
Replace top grille.
IMPORTANT:
Be sure the power switch is set to the ON position
after cleaning refrigerator or changing light bulbs.
Water System Preparation
(on some models)
Please read before using the water system.
Immediately after installation, follow the steps below to make
sure that the water system is properly cleaned.
sure that the water system is properly cleaned.
1.
Open the freezer door and turn off the ice maker by lifting up
the wire shutoff arm as shown.
the wire shutoff arm as shown.
NOTES:
■
If your model has a base grille filter system, make sure the
base grille filter is properly installed and the cap is in the
horizontal position.
base grille filter is properly installed and the cap is in the
horizontal position.
■
■
■
■
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system.
of unknown quality without adequate disinfection before
or after the system.
2.
Use a sturdy container to depress the water dispenser bar
until the water begins to flow. Flush the water system by
dispensing and discarding 2 to 3 gal. (8 to 12 L) of water.
Cleaning the system will take approximately 6 to 7 minutes
and will help clear air from the line. Additional flushing may be
required in some households.
until the water begins to flow. Flush the water system by
dispensing and discarding 2 to 3 gal. (8 to 12 L) of water.
Cleaning the system will take approximately 6 to 7 minutes
and will help clear air from the line. Additional flushing may be
required in some households.
NOTE:
As air is cleared from the system, water may spurt out
of the dispenser.
3.
Open the freezer door and turn on the ice maker by lowering
the wire shutoff arm. Please refer to the “Ice Maker and
Storage Bin/Bucket” section for further instructions on the
operation of your ice maker.
the wire shutoff arm. Please refer to the “Ice Maker and
Storage Bin/Bucket” section for further instructions on the
operation of your ice maker.
■
Allow 24 hours to produce the first batch of ice.
■
Discard the first three batches of ice produced.
Normal Sounds
Your new refrigerator may make sounds that your old one didn’t
make. Because the sounds are new to you, you might be
concerned about them. Most of the new sounds are normal. Hard
surfaces, such as the floor, walls, and cabinets, can make the
sounds seem louder. The following describes the kinds of sounds
and what may be making them.
make. Because the sounds are new to you, you might be
concerned about them. Most of the new sounds are normal. Hard
surfaces, such as the floor, walls, and cabinets, can make the
sounds seem louder. The following describes the kinds of sounds
and what may be making them.
■
If your product is equipped with an ice maker, you will hear a
buzzing sound when the water valve opens to fill the ice
maker for each cycle.
buzzing sound when the water valve opens to fill the ice
maker for each cycle.
■
Your refrigerator is designed to run more efficiently to keep
your food items at the desired temperatures and to minimize
energy usage. The high efficiency compressor and fans may
cause your refrigerator to run longer than your old one. You
may also hear a pulsating or high-pitched sound from the
compressor or fans adjusting to optimize performance.
your food items at the desired temperatures and to minimize
energy usage. The high efficiency compressor and fans may
cause your refrigerator to run longer than your old one. You
may also hear a pulsating or high-pitched sound from the
compressor or fans adjusting to optimize performance.
1. Top grille
2. Cabinet side trim
3. Louver panel
2. Cabinet side trim
3. Louver panel
1. Power On/Off switch
1