Hoshizaki HR24A User Manual

36

If you would like to reverse the door swing, follow the steps below. 

1) Make sure the appliance is off and unplugged.
2) Remove the fasteners securing the top panel. See Fig. 1. Being careful not to pull on the 

wires to the control panel and door switch, lift off the top panel. Secure the top panel so 
that it does not interfere with the upper hinge or top panel bracket and will not fall.

3) While maintaining a hold on the door, remove the fasteners securing the upper hinge to 

the right side of the appliance. Lift off the door and upper hinge.

4) Remove the top panel bracket from the left side of the appliance, then secure it to the 

right side of the appliance.

5) Remove the 2 outside plastic plugs from the lower left side of the appliance.
6) Remove the lower hinge from the right side of the appliance, then secure it to the left 

side of the appliance. 

7) Place the 2 plastic plugs in the holes on the lower-right side of the appliance.
8) Remove the plastic plugs and the handle from the door. 
9) Secure the handle to the right side of the door. Place the plugs in the open handle holes 

on the left side of the door and in the hinge hole on the right side of the door.

10)  Place the door onto the lower hinge, then place the upper hinge in the door and secure 

to the left side of the appliance.

11) Make sure the door is level. If not, adjust the door using the slots in the hinges.
12) Check that the wiring is connected and routed properly, then replace the top panel in its 

correct position. Secure the top panel.

Plastic Plugs

Top Panel Bracket

Handle

Upper Hinge

Lower Hinge

Plastic Plugs

Control Panel

Door Switch

Top Panel