GE PVB94 User Manual

• The downdraft vent is shipped with the 

discharge outlet pointing straight down 

and can be changed to the left or right 

side.

• The blower outlet is sized for 3-1/4" x 10" 

and can be transitioned to 6" round.

The entire blower mounting plate can be  

adjusted 3-1/2" to the left or right. This will 

help to align vent discharge to house  

ductwork.

The blower assembly may be removed and turned  

90° for a left- or right-side discharge.
• A left or right 90° direction adjustment should be  

performed before dropping into the countertop  

opening.

• Flatten the shipping box to use as a pad.
• Lay the vent on its back and onto the pad.

• Remove the 4 screws holding the blower to  

the mounting plate assembly. Retain screws.

• Remove blower assembly; turn it over to access 

the 4 nuts holding the blower to the mounting 

plate. Remove the nuts.

 Do not lift motor by the power cable.

• Turn the blower to the left or right discharge  

direction and reinstall the 4 nuts.

• Reinstall blower and mounting plate with original 

screws.

• Temporarily place vent into the countertop  

opening. 

• Push the vent all the way to the back of  

the opening.

• If you are transitioning to 6" round (obtained  

locally), place transition piece over the discharge 

outlet.

• Mark the location and remove the assembly.
• Cut holes and install ductwork connections.
• Order JXRb67 for installation of the blower  

and motor below the floor.

• Order JXbC67 for installation of the blower  

and motor outdoors.

Discharge Down 

(As Supplied)

Loosen Screws 

to Adjust  

3-1/2" to  

Left or Right

Discharge Down 

(As Supplied)

Discharge Left

Discharge Right