GE 16207744P008 User Manual

14

Water Supply to the Icemaker 

(on some models)

If the refrigerator has an icemaker, it will have to be
connected to a cold water line.

A water supply kit (containing copper tubing,
shutoff valve, fittings and instructions) is available 
at extra cost from your dealer or from Parts and
Accessories, 800-626-2002.

Refrigerator Location

Do not install the refrigerator where the
temperature will go below 60°F (16°C) 
because it will not run often enough to maintain
proper temperatures.

Install it on a floor strong enough to support it 
fully loaded.

Clearances

Allow the following clearances for ease of
installation, proper air circulation and 
plumbing and electrical connections:

Sides 5/8

″

(15 mm)

Top 1

″

(25 mm)

If built-in, allow 7/8

″

(22 mm) for hinge covers.

Back 1

″

(25 mm)

If the refrigerator is against a wall on either side,
allow the following door clearances:

20

′

, 22

′

, and 24

′

models 3/4

″

(19 mm)

27

′

models 1

1

/

2

″

(38 mm)

Rollers adjust so the door closes easily when
opened about halfway. [Raise the front about
5/8

″

(15 mm) from the floor.]

To assure that the doors will close automatically
from a halfway open position, there is a built-in tilt
from the front to the back of the cabinet. Side-by-
side refrigerators also have specially designed door
hinges that lift both doors slightly when opened,
allowing the force of gravity to help close them
securely.

Rollers adjust so the refrigerator is firmly
positioned on the floor and does not wobble.

Rollers allow you to move the refrigerator away
from the wall for cleaning. 

To adjust the rollers, remove the base grille by pulling
it out at the bottom.

Turn the roller adjusting screws clockwise to raise
the refrigerator, counterclockwise to lower it. Use an
adjustable wrench (3/8

″

hex head bolt) or pliers.

To replace base grille, align prongs on back of grille
with clamps in cabinet and push forward until grille
snaps into place.