GE PCT916 User Manual

Page of 28
1
If you have questions, call 1.800.561.3344 or visit our website at:
www.geappliances.ca
Built-In Wall Oven
27
 (68.6 cm) models
Installation
Instructions
JCKS10, JCKP30, JCKP70, PCK916, PCK920
Materials Needed
Strain Relief Clamp
for 1/2
 conduit
Junction
Box
Wire Nuts
91 cm (36
) of String
Before You Begin
Read these instructions carefully and completely.
IMPORTANT
—Save these
instructions for local inspector’s use.
IMPORTANT
—Observe all
governing codes and ordinances.
• Note to Installer—Be sure to leave these
instructions with the consumer.
• Note to Consumer—Keep these
instructions for future reference.
• Proper installation is the responsibility
of the installer and product failure due
to improper installation is NOT covered
under warranty.
• NOTE—This appliance must be properly
grounded.
ATTENTION INSTALLER
All electric wall ovens must be hard wired
(direct wired) into an approved junction
box. A plug and receptacle is NOT permitted
on these products.
31-10666-3   
    11-07 JR
Tools Needed
1/8
 (3 mm) Drill Bit and
Electric or Hand Drill
Phillips
Screwdriver
Parts Included
(Appearance will vary.)
Screws for Installation
(8-18 x .750 flat head
Phillips wood screws)
30
 (76.2 cm) models
JCTP30, JCTP70, PCT916, PCT920
76.2 cm (30
)
Metal Bottom Trim
Assembly
68.6 cm (27
)
Metal Bottom Trim
WB07T10578 – Black
WB07T10579 – SS
Optional 68.6 cm (27
)
Metal Bottom Trim Assembly
(on some models or can be
purchased separately)