Smeg A1-6 User Manual
Instructions for the user
11.2 Removing the door
Open the door completely and fit the pins (supplied) into the holes from the
inside. Close the door to an angle of about 45°, lift it and remove it from
its seat. To replace, fit the hinges into the grooves provided, then lower
the door until it comes to rest and extract the pins. If the pins are lost, two
screwdrivers can also be used.
inside. Close the door to an angle of about 45°, lift it and remove it from
its seat. To replace, fit the hinges into the grooves provided, then lower
the door until it comes to rest and extract the pins. If the pins are lost, two
screwdrivers can also be used.
11.3 Oven door seal
To permit thorough cleaning of the oven, the seal
may be removed. Before removing the seal, take off
the door as described above. Once the door has
been taken off, lift the tabs at the corners as shown
in the figure.
may be removed. Before removing the seal, take off
the door as described above. Once the door has
been taken off, lift the tabs at the corners as shown
in the figure.
11.4 Lubrication of gas taps
With time it may happen that the gas taps get blocked and hard to turn.
Clean them inside and re-grease them. This operation must be done
by a specialised technician.
Clean them inside and re-grease them. This operation must be done
by a specialised technician.
65