U-Line U-3045RDCS-01 User Manual

Page of 21
14
u-line.com
Door Alignment and Adjustment
Align and adjust the door if it is not level, or is not sealing properly. If 
the door is not sealed the unit may not cool properly, or excessive 
frost or condensation may form in the interior.
NOTICE
Properly aligned, the door’s gasket should be firmly in 
contact with the furniture cabinet all the way around the 
door (no gaps). Carefully examine the door’s gasket to 
assure that it is firmly in contact with the furniture cabinet. 
Also make sure the door gasket is not pinched on the hinge 
side of the door.
CAUTION
!
• Do not attempt to use the door to raise or pivot your unit. 
This would put excessive stress on the hinge system.
• Pay special attention to the Cable Arm. Make sure not to 
over extend or damage it during door alignment.
Stainless Models (Removing Wrap)
1. Open door completely.Remove the two wrap screws from the 
bottom of the stainless steel door wrap.
2. Gently pull bottom of wrap away from door.
3. The Wrap hinges on top of the door. Carefully pull wrap away and 
then up. See below.
4. If door being adjusted houses the 
display unit, remove cable from display 
by pressing in the release tab on the 
cable connector.
Alignment and Adjustment
1. Using a T-25 Torx Bit, loosen each 
pair of Torx head screws on both the upper and lower hinge 
plate.
2. Square and align door as necessary.
3. Tighten Torx head screws on hinge.
4. If necessary re-connect display and re-install stainless steel wrap.
3000 Series Doors
Wrap Screws
Cable Arm
Step 1
Step 2
Door Top
Door Bottom
Press Tab  Down
T-25 Torx  Screw
T-25 Torx  Screw