Jura Capresso ENA 4 User Manual

Since the Water Hardness Selector is off, the machine will not
remind you when to decalcify. This could clog and damage your
machine. 

17.3 MANUAL CLEARYL REPLACEMENT
If the filter is more than 2 months old and the display does not
indicate to replace filter, replace as follows. 

. 

• Push and hold the P button until the display shows 

• Push the button again. The display shows again 

• Turn the Rotary Dial until the display shows 

• Push the Rotary Dial. The display shows

• Continue with steps 3 to 12 in chapter 17.2 above.

17.4 DO NOT LET THE CLEARYL FILTER DRY OUT!
If the filter is not immersed in water for a few days the granular
inside will dry out and will block any water from passing through.
• If machine is not used for a few days, always leave some water

in the water tank. This way the filter will not dry out. Once you 
start using the machine again, fill the water tank with fresh 
water and process approx. 2 oz. of water through the hot 
water spout. Now you have fresh water for your first cup of 
coffee.

• If the machine is not used for a longer period of time, empty

the water container and remove the CLEARYL filter. Fill a glass
with at least 2 inches of water and immerse the filter. Place the
glass in the refrigerator.

• When you use the machine again, install the filter.

18. AUTOMATIC CLEANING CYCLES
18.1 CLEANING WITH SPECIAL TABLET 
The machine monitors how many coffees are brewed and how

often the rinsing program is activated. After approx. 180 coffees
or 80 initial rinse cycles the display will show 

/ 

.

You can continue to make coffee, however we highly recom-
mend cleaning the machine as described below within the next
few days. This cleaning program will remove oil build-ups in the
brewing chamber. It takes only about 15 minutes. Use the
enclosed white cleaning tablet. The machine comes with a pack
of 2 tablets. To re-order see chapter 31.
Important: Once the cleaning program has started do not
interrupt the procedure.

/ 

Make sure the water tank is at least half full.
1. Press the Rinse button (Fig. 4). Display shows 

2. Remove the complete drawer with the grid and the used 

coffee container (Fig. 1, 12 to 14) and empty the tray and the
used coffee container. Note: Even if tray is empty it must be 
removed for 20 seconds.

3. Replace the complete assembly.
4. The display shows 

5. Place a cup underneath the coffee spouts and push the 

Rotary Dial. The display shows 

and water comes

through the coffee spouts. This process stops after a few 
times and the display shows 

.

6. Open the pre-ground coffee chute and drop in one white 

cleaning tablet (Fig. 24).

7. Close the pre-ground coffee chute. The display shows 

.

8. Push the Rotary Dial. The display shows 

. The 

machine starts the automatic cleaning program by dispensing
water in intervals in the cup underneath the coffee spout. The
program stops automatically and the display shows 

24.