Mr. Coffee PRX30 User Manual
Clean Mode
Indicator
(Red)
PM Indicator
On/Off
Indicator
(Red)
Hour
Set
Minute
Set
Auto Start
Indicator
(Green)
1-4 cup
Indicator
(Yellow)
Auto Start
Time
Mode
Select
Warmer
Temperature
Dial
Clock
Display
IMPORTANT
Clean Your Mr. Coffee Coffeemaker Before Using the First Time!
Wash decanter, lid and removable filter basket in mild detergent and water.
Rinse each thoroughly. Follow steps 4 through 6 below (with water only) to
clean the inside of your coffeemaker.
Rinse each thoroughly. Follow steps 4 through 6 below (with water only) to
clean the inside of your coffeemaker.
5
Setting the Clock and Timer
To Set the Clock
1.
Press and hold the HOUR button until the correct hour is reached. The PM INDICA-
TOR light in the upper left corner of the clock display will illuminate to indicate PM
time.
TOR light in the upper left corner of the clock display will illuminate to indicate PM
time.
2.
Press and hold the MINUTE button until the correct time is shown.
Note: It is not necessary to set the clock in order to brew coffee. If the HOUR or MINUTE
buttons are not pressed, the clock will display 12:00 and will not change. You must
set the correct time in order for the clock to begin operation, or to brew at a pre-set
time.
set the correct time in order for the clock to begin operation, or to brew at a pre-set
time.
To Pre-Set the Brewing Time
1.
Press and hold the AUTO button until the AUTO START light begins to flash.
2.
Release the AUTO button. The AUTO START indicator light will continue to flash let-
ting you know the AUTO START time is being set.
ting you know the AUTO START time is being set.
3.
Press the HOUR button and then the MINUTE button until the desired time appears
in the clock display. This is the time you want your coffeemaker to begin brewing
automatically.
in the clock display. This is the time you want your coffeemaker to begin brewing
automatically.
4.
Press and release the AUTO button. The AUTO START indicator will go out. The
clock display will return to the current time.
clock display will return to the current time.
To Brew Automatically at the Pre-Set Time
1.
Follow steps #1 through #5 in the “Brewing Coffee” section of these instructions.
2.
Press the SELECT button until the AUTO START light is illuminated, then release.
The AUTO START light will remain lit. The coffeemaker will automatically start brew-
ing at the pre-set time.
The AUTO START light will remain lit. The coffeemaker will automatically start brew-
ing at the pre-set time.
To Check the Auto Start Time
Press and hold the AUTO button until the AUTO START light flashes. The pre-set
time will appear in the clock display. After seven seconds the clock display will return
to the current time.
time will appear in the clock display. After seven seconds the clock display will return
to the current time.
To Brew Four Cups or Less (Small Batch Mode)
If you are only brewing four cups or less, press and hold the SELECT button until the
AUTO START light and the 1-4 CUP lights are both illuminated. This mode extends
the brewing cycle by approximately 30% to ensure optimal saturation of the coffee
AUTO START light and the 1-4 CUP lights are both illuminated. This mode extends
the brewing cycle by approximately 30% to ensure optimal saturation of the coffee