Bertazzoni X304PIRCR User Manual

 

12

INSTALLING THE ANTI‐TIP Stability DEVICE 
The anti‐tip bracket shipped with the range must 
be properly secured to the rear wall as shown in 
the picture below.  

The height of the bracket from the floor must be 
determined after the range legs have been 
adjusted to the desired height and after  the 
range has been levelled.  

Measure the distance from the floor to the 
bottom of the anti‐tip bracket receptacle on the 
back of the appliance. 

Position the two anti‐tip brackets on the wall at 
the desired height plus 1/8" (0.32 cm). The 
brackets must be placed at 2”5/16 (6,0 cm) from 
the side of the range. The distance between the 
two bracket is 25”1/4 (64,1 cm).  

Secure the brackets to the wall with appropriate 
hardware. 

Slide the range against the wall until the brackets 
are fully inserted into their receptacles on the 
back of the range. 

 

 

 

 

INSTALLATION REQUIREMENTS 

A properly grounded and horizontally‐mounted 
electrical receptacle Type NEMA 14‐50R should 
be installed no higher than 3" (7.6 cm) above the 
floor, no less than 2” (5 cm) and no more than 8” 
(20,3 cm) from the right side (facing product); 
refer to ELECTRICAL CONNECTION section pag. 
13. 

Check all local code requirements. 
 

An agency‐approved, properly‐sized manual shut‐
off valve should be installed no higher than 3" 
(7.6 cm) above the floor and no less than 2” (5 
cm) and no more than 8” (20.3 cm) from the left 
side (facing product).  

To connect gas between shut‐off valve and 
regulator, use agency‐approved, properly sized 
flexible or rigid pipe. Check all local code 
requirements.