Homesmart Appliance SRS-LYNC-M User Manual
APPENDIX C
REMOTELY MANAGING YOUR ROOM SYSTEM USING INTEL AMT
REMOTELY MANAGING YOUR ROOM SYSTEM USING INTEL AMT
127
smarttech.com/kb/170450
Control
Procedure
Notes (if any)
IPV4 Address
Type the IPv4 address for the room system.
This control is only available if you
disabled DHCP.
disabled DHCP.
Subnet Mask
Address
Address
Type the subnet mask address for the room
system.
system.
This control is only available if you
disabled DHCP.
disabled DHCP.
Default Gateway
Address
Address
Type the default Gateway address for the room
system.
system.
This control is only available if you
disabled DHCP.
disabled DHCP.
Preferred DNS
Address
Address
Type the preferred DNS address for the room
system.
system.
This control is only available if you
disabled DHCP.
disabled DHCP.
Alternate DNS
Address
Address
Type the alternate DNS address for the room
system.
system.
This control is only available if you
disabled DHCP.
disabled DHCP.
Activate Network Access
Select Y to transition Intel MEBx to the POST
provisioning state if all network settings are
configured.
provisioning state if all network settings are
configured.
OR
Select N to disable this feature.
You must activate network access to
remotely manage your room system
using Intel AMT.
remotely manage your room system
using Intel AMT.
Unconfigure Network
Access
Access
Select Full Unprovision to fully reset the
network configuration.
network configuration.
OR
Select Partial Unprovision to reset the network
configuration except for Pre-Shared Key (PSK)
settings, remote configuration settings and
network settings.
configuration except for Pre-Shared Key (PSK)
settings, remote configuration settings and
network settings.
Remote Setup And Configuration
Current Provisioning
Mode
Mode
View the current provisioning TLS mode: Public
Key Infrastructure (PKI), PSK or None.
Key Infrastructure (PKI), PSK or None.
Provisioning Record
View the room system’s provision PSK/PKI data.
Provisioning Server
IPV4/IPV6
IPV4/IPV6
Type the port number of the Intel AMT
provisioning server.
provisioning server.
The default port is 9971.
Provisioning Server
FQDN
FQDN
Type the FQDN of the provisioning server
mentioned in the certificate.
mentioned in the certificate.
RCFG
Start Configuration
Select Y to activate remote configuration.
OR
Select N to not activate remote configuration.
TLS PSK
Set PID and PPS
Type the provisioning ID (PID) and provisioning
pre-shared key (PPS) in the dash format.
pre-shared key (PPS) in the dash format.
Start Configuration
Select Y to delete the PID and PPS.
OR
Select N to not delete the PID and PPS.