GE JVM1653SH User Manual

Find the studs, using one of the following 
methods:
A.

Stud finder – a magnetic device which 
locates nails.

Use a hammer to tap lightly across the 
mounting surface to find a solid sound. 
This will indicate a stud location.

After locating the stud(s), find the center by 
probing the wall with a small nail to find the 
edges of the stud. Then place a mark halfway
between the edges. The center of any adjacent 
studs should be 16

″ or 24″ from this mark.

Draw a line down the center of the studs.

Remove the turntable, installation instructions,
filters, exhaust adaptor, damper, shelf and the
small hardware bag. Do not remove the Styrofoam
protecting the front of the oven.

Fold back all 4 carton flaps fully against carton
sides. Then carefully roll the oven and carton over
onto the top side. The oven should be resting in
the Styrofoam.

Wall 
Studs

Center

Carton

Pull the carton up and off the oven. 

Open the oven door and remove any packing
material, if present, from inside the oven.

Styrofoam

Set the oven upright. Remove and properly discard
plastic bags and Styrofoam.

The mounting plate is attached to the back of the
oven. Remove the two screws holding it to the oven.
The plate will be used as the rear wall template and
for mounting the oven to the wall.