Adder Technology X200 User Manual

Password protection allows you restrict access to the system only to authorised 
personnel. A password first needs to be set and then, using the keyboard 
attached to the remote X200 module, a simple key sequence allows the system 
to be quickly and securely detached from its peripherals.

1  Simultaneously, press the hotkeys (by default, 

 and 

) along with 

 

to enter configuration mode.

2  Press   followed by 

.

3  Now enter your new password, within the following constraints:

•  Passwords are NOT case sensitive,
•  Passwords may be any length from one character to a maximum of forty 

characters,

•  The following keys may NOT be used: 

, 

, 

, or 

 

4  When you have entered the password, press 

 to signal its completion.

5  Press 

 once more to exit configuration mode.

For full details about how to lock and unlock the system using your password, 
please see the 

and operation’ chapter.

1  Connect the X200 module to a computer in the same manner as you would 

to carry out a flash upgrade - see 

2  While power is applied, set the X200 upgrade switch SW1 to its ON 

position.

3  Remove power from the X200 unit and then re-apply power.
4  Set the computer serial settings to the following: 19200, n, 8, 1
5  Using ‘TeraTerm’ (recommended) or some other terminal program, send 

“CLEAR<cr>” - in upper or lower case from the keyboard. The X200 unit 
should respond with “OK”.

6  The password is now clear and all factory default settings restored.

In order to allow a 3 button mouse (or scroll wheel mouse) to be used to change 
channels, it is first necessary to enable the feature using the process described 
here. For details about switching using a mouse - see 

1  Simultaneously, press the hotkeys (by default, 

 and 

) along with 

 

to enter configuration mode.

2  To enable mouse switching: Press     
  To disable mouse switching: Press     
3  Press 

 to exit configuration mode.