Cabletron Systems 8H02-16 User Manual

Chapter 3: Installation

4. Verify that a Link exists by checking that the port RX LED is flashing 

green or yellow, or on solid green. If the RX LED is off, perform the 
following steps until it is on:

a.

Check that the power is turned on for the device at the other end of 
the Link.

b. Verify proper crossing over of fiber strands between the 

applicable port on the 8H02-16 and the fiber optic device at the 
other end of the fiber optic link segment.

c.

Verify that the fiber connection meets the dB loss specifications 
outlined in Chapter 2.

If a Link has not been established, contact Cabletron Systems Technical 
Support. Refer to Section 1.7, Getting Help, for details.

The 8H02-16 is now ready to be set up through Local Management. Refer 
to Chapter 6, Local Management, to configure the 8H02-16.

The port RX LED flashes green and yellow during bootup.